Panasonic PV-DV73 operating instructions Memory-Stop Editing, Mix, Jog Key

4, 5PAUSE

To listen to the desired audio sound, set the 12bit AUDIO setting of the VCR mode MENU (Menu OSD: p. 108) as follows:

12bit AUDIO:The following selections are available for 12 bit AUDIO dubbed recordings only (sound recorded in SP mode only).

ST 1	Set this position to listen to the
	original sound.
ST 2	Set this position to listen to the
	audio dubbed sound.
	Set this position to listen to both
MIX	the original sound and the audio
	dubbed sound.

Note

•When a 16 bit recording is dubbed over, the original audio of the recording will be erased.

•When a 12 bit recording is dubbed over and played back, and MIX is selected as the AUDIO, both the original audio and the dubbed audio are played back.

•If you recorded in LP mode, you cannot use the A.DUB feature.

Memory-Stop Editing

You can set an automatic Dubbing stop point.

DRESET

AMENU

Editing Features

4 Press (PAUSE) to start Audio Dubbing. “A.DUB ” indication appears.

•Connect the Palmcorder to the TV in order to monitor the sound.

(p. 38)

Only NTSC (National Television Standards Committee) recorded tapes can be audio dubbed. The following screen appears if the tape was not recorded in NTSC format.

5 Press (PAUSE) to stop Audio Dubbing.

•If the microphone used for dubbing gets too near the speaker of your TV,

a howling noise (feedback) may occur.

•If the tape position is in or was started in a blank section, you cannot use the A.DUB feature.

APress MENU to display the VCR					Editing
					Features
	FUNCTIONS menu screen.
BRotate JOG KEY to select
				DISPLAY
	SETUP	, and then press		JOG KEY
	to display the DISPLAY SETUP menu.
CRotate JOG KEY to select
	C. DISPLAY		, and then press JOG
	KEY to set to		MEMORY.
DPress MENU to exit MENU mode.
	Then, press RESET on the remote
	control to reset the Counter Memory
	to M 0:00.00.
Now, rewind to the editing start point,
and continue with steps 2-5. The tape will
now stop automatically at “M 0:00.00”.

45