Camera Recording
Recording via EVF or LCD Monitor
View recording scene on EVF (Electronic Viewer Finder) or LCD (Liquid Crystal Display) monitor.
1 |
|
3 | 3 |
BRIGHT | VISION |
ADJUSTMENT | ADJUSTMENT |
CAUTION :
Rotating partially open LCD monitor may block cassette door and damage Camcorder body.
4
Built-in
Microphone
2, 6
5
WARNING :
•Do not leave the camcorder with the EVF aimed directly at the sun. This may cause damage to the internal parts of the EVF.
Note:
•When Camcorder is aimed at excessively bright objects, or bright lights, a vertical bar may appear in the picture. This is normal for the CCD
•Using LCD monitor reduces battery operation time. Return LCD monitor to locked position when not in use.
Before you begin...
•Connect Camcorder to power source.
•Insert cassette with record tab (page 11).
1 Press
•If you want to record using EVF, close and lock LCD monitor.
2 Set POWER to
CAMERA.
•Be sure POWER is fully turned to
CAMERA position.
•EVF or LCD monitor
turns on/off by the POWER switch.
•EVF shuts off when LCD monitor is opened and turns back on when LCD is closed.
•Both EVF and LCD monitor turn on when LCD is at 180° (see above left). This allows both you and the subject to view the recording.
3 LCD : Press BRIGHT ADJUSTMENT to adjust LCD monitor brightness level.
EVF : Look into EVF and adjust VISION ADJUSTMENT to your eyesight.
4 Hold down TAPE SPEED for about 1 second to change tape speed to SP/SLP (page 11).
5 Press RECORD/
PAUSE to start or pause recording.
6 Set POWER to OFF when finished.
•To remove the cassette, slide the TAPE EJECT switch (page 11).
Basic Operation
17