Samsung SPD-1000 user manual

Page 2

The lightning flash with an arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

INFORMATION -This equipment has been tested and found to comply with limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

WARNING - Changes or modifications not expressly approved by the manufacturer

could void the user’s authority to operate the equipment.

CAUTION : To prevent electric shock and risk of fire hazards:

Do NOT use power sources other than that specified. Do NOT expose this appliance to rain or moisture.

This installation should be made by a qualified service person and

should conform to all local codes.

Image 2
Contents English Page Features Contents Precautions Persons is not recommendedBody Main Body Port Block Rear panelCamera Initial Settings Setting Baud Rate Based on DVR ModelSW2 #7 SW2 #8 Setting RS-485 TerminationSetting Camera ID Switch On the PathSW1-#1 SW1-#2 SW1-#3 SW1-#4 SW1-#5 SW1-#6 SW1-#7 SW1-#8 100 SW1-#1 SW1-#2 SW1-#3 SW1-#4 SW1-#5 SW1-#6 SW1-#7 SW1-#8 150 Pin Order Pin Name Purpose Setting Termination ResistanceAuxiliary Video Out Port +12V Output PortPreparation for Cable InstallationProducts Sold Separately Following products are provided separatelyWall Mount STB-280PW Cable Connection Installation of SPD-1000Camera holder Connect the Power Adapter’s plug to the Power Wall MountSTB-230PWInstallation cover along the groove Installing the SPD-1000 on a CeilingTo complete installation, rotate Installing the SPD-1000 Wall Mount OSD Menu Organization Installing the Dome Housing STH-1000PIFunctional Description ExposureON/OFF Main Menu PTZ Camera User Menu SettingsCamera Setting Zoom TrackingExposure WB ModeWhite Balance Camera exposure can be controlledSens-Up Back LightSsnr Samsung Super Noise Reduction No noise reduction effectOthers Camera Setting OhterDay & Night Select the Preset number Set up the Zoom and Focus Sequence SettingSequence Setting Menu Setting ClearPan 350˚ Auto Run in Pan direction T SettingTime can be set up by the unit of 1-59 SEC and 1-59 MIN TraceArea Name Chinese, numbers can be entered. When you finish inputtingName, adjust the position mark to SET using the joystick To enter the area name. a maximum of 12 letters EnglishOSD Setting Camera Name Camera name is set upPreset Name Preset NamePreset/Swing/Group/Tour/Trace/A.PAN Alarm SettingInput 1, Input 2 Alarm Input Mode/Priority/Method is set up ON/OFF Alarm is enabled in on modeStatus Status of dome camera setting is displayedInitialize Initialization MenuProduct Structure Auto/Manual1/50~1/120000 SpecificationsInstallation 2 Mini PTZ Dome Camera Control Declaration of Conformity