Samsung SPD-1000 user manual Initialize, Status, Initialization Menu

Functional Description

MD Dwell Time : When was motion detection in each preset that have established motion detection function, it set time that keep relevant preset. For detailed settings of the Motion Detection for each Preset menu, see page 42 and 43.

Alarm Setting		Alarm Setting
Output Clear		Output Clear
Input 1	OFF	Input 1	OFF
Input 2	OFF	Input 2	OFF
Output	OFF	Output	OFF
Enable	OFF	Enable	OFF
MD Dwell Time	OFF 30 SEC	MD Dwell Time	ON 30 SEC

ON/OFF : It can be set up how long the operation will be kept when the motion is detected. (1-59 sec, 1-59 min)

6) Initialize

•Initialization Menu

Main Menu	Initialize
Camera Setting	Power ON Reset
Sequence Setting	Initial Position
P/T Setting	Factory Default Set
OSD Setting	Camera Default Set
Alarm Setting	Auto Refresh	OFF
Initialize
Status

Power On Reset : Camera is initialized into the original status of power input.

Initial Position : If you want to set the default direction of the camera so that the camera faces that direction when the power is turned on, you can set up the desired Pan and Tilt for the camera.

Factory Default Settings : Camera is initialized into the factory default settings. Data including Preset is deleted. This function is used for initialization all settings.

Camera Default Settings : If only the camera module is replaced due to camera module failure, the new camera module can be set up with the settings of the old camera module.

Auto Refresh : The electric circuit and the status of the equipment parts within the camera are optimized regularly. (The cycle can be set up.) If camera faces toward a certain source of light or if the settings cannot be kept because of the long time rotation filming of a certain area, the Auto Refresh function is used to maintain and re- set the existing camera settings. Default setting is OFF.

OFF, 1-7 Days : This function is disabled in the OFF mode. 1-7 Days enables the Auto Refresh operation in the interval of the selected days. Auto Refresh takes less than 10 seconds. The message “Auto Refresh” disappears after finishing the operation.

7) Status

The status of dome camera setting is displayed.

Main Menu	Camera Status
Camera Setting	CAM MODER	= 10NC
Sequence Setting	CAM VERSION	= 4.6
P/T Setting	DOME VERSION	= 1.00
OSD Setting	CON PROTOCOL	= SAMSUNG TW
Alarm Setting	DOME ID	= 001
Initialize	CONTROLLER	= Duplex-9600
Status
Cam Model = 10NC	Camera Model
Cam Version = 4.6	Camera S/W Version
Dome Version = 1.00	Control Board S/W Version
Dome ID=001	Dome Camera ID
Controller=Duplex-9600	Communication Mode Setup

56 57