AXIS M1034-W Network Camera
Hardware Overview
NOTICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See Electromagnetic Compatibility (EMC) for regulatory requirements.
Control button - The control button is used for:
•Connecting to an AXIS Video Hosting System service. See page 41. To connect, press and hold the button for about 1 second until the Status LED flashes green.
•Connecting to AXIS Internet Dynamic DNS Service. See page 42. To connect, press and hold the button for about 3 seconds.
•Resetting the product to factory default settings. See page 51.
WLAN pairing button - For connecting to an access point through push button configuration (PBC).
Power connector - Mini DC connector
I/O terminal connector - Use in applications for e.g. motion detection, event triggering, time lapse recording and alarm notifications. In addition to an auxiliary power and a GND pin, the I/O terminal connector provides the interface to:
•Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
•Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example: PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes active (shown under System Options > Ports & Devices).
LED Indicators
LED | Color | Indication |
|
|
|
Network | Green | Steady for connection to a 100 MBit/s network. Flashes for network activity. |
| Amber | Steady for connection to a 10 MBit/s network. Flashes for network activity. |
| Unlit | No network connection. |
|
|
|
Status | Green | Steady green for normal operation. |
| Amber | Steady during startup and when restoring settings. Flashes while waiting to record an audio clip. |
| Red | Flashes while recording audio. Slow flash for failed upgrade. |
|
|
|
Power | Green | Normal operation. |
| Amber | Flashes green/amber during firmware upgrade. |
|
|
|
Wireless | Unlit | Wired mode. |
| Green | Steady for connection to a wireless network. Flashes for network activity. |
| Red | Steady for no wireless network connection. Flashes while scanning for wireless networks. |
| Amber | Steady during wireless network pairing. Flashes for wireless network activity. |
|
|
|
7