AXIS
Event Configuration
An event in the camera is when an Event Type is activated and causes certain actions to be performed. The event type is the set of parameters (or conditions) that specifies how and when which actions will be performed. A common event type is when the camera uploads images when an alarm occurs. Many event types use an Event Server to receive uploaded images.
This section describes how to set up event servers and event types, i.e. how to configure the camera to perform certain actions when events (e.g. alarms) occur.
Definitions
Event type | A set of parameters describing how and when the camera will perform certain actions | |
|
|
|
Triggered Event - see page 21 | The circumstances that start an event. | E.g. on a signal from an external device, such as a |
| door switch or a motion sensor. | |
|
| |
|
|
|
Scheduled Event - see page 22 | The circumstances that start an event. | E.g. at a |
|
|
|
Action | What occurs when the event triggers. | E.g. the upload of images to an FTP server, |
| notification, etc. | |
|
| |
|
|
|
Event Servers
Event Servers are used to receive e.g. uploaded image files and/or notification messages. To set up Event server connections in your camera, go to Setup > Event Configuration > Event Servers and enter the required information for the required server type.
Server type | Purpose | Information required | |
|
|
|
|
FTP Server | • | Receives uploaded images | • Descriptive name of your choice |
|
|
| • Network address (IP address or host name) |
|
|
| • User Name and Password (for FTP server) |
|
|
| • Upload path e.g. images/ |
|
|
|
|
HTTP Server | • | Receives notification messages | • Descriptive name of your choice |
| • | Receives uploaded images | • URL (IP address or host name) |
|
|
| • User Name and Password (for HTTP server) |
|
|
|
|
TCP Server | • | Receives notification messages | • Descriptive name of your choice |
|
|
| • Network address (IP address or host name) |
|
|
| • Port number |
|
|
|
|
For details on each setting, please see the online help 
available from each web page.
When the setup is complete, the connection can be tested by clicking the Test button (the connection test takes approximately 10 seconds).
Event Types
An Event Type describes how and when the camera will perform certain actions.
Example: If somebody passes in front of the camera and an event that uses motion detection has been configured to act on this, the camera can e.g. record and save images to an FTP server, and/or send a notification