Safety information

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol indicates that dangerous voltage consisting a risk of electric shock is present within this unit.

This exclamation point symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING

•To reduce the risk of ﬁ re or electric shock, do not expose this appliance to rain or moisture.

•To prevent injury, this apparatus must be securely attached to the ﬂ oor/wall in accordance with the installation instructions.

•If this power supply is used at 24V AC, a suitable plug adapter should be used.

WARNING

1.Be sure to use only the standard adapter that is speciﬁ ed in the speciﬁ cation sheet. Using any other adapter could cause ﬁ re, electrical shock, or damage to the product.

2.Incorrectly connecting the power supply or replacing battery may cause explosion, ﬁ re, electric shock, or damage to the product.

3.Do not connect multiple cameras to a single adapter. Exceeding the capacity may cause abnormal heat generation or ﬁ re.

4.Securely plug the power cord into the power receptacle. Insecure connection may cause ﬁ re.

5.When installing the camera, fasten it securely and ﬁ rmly. The fall of camera may cause personal injury.

6.Do not place conductive objects (e.g. screwdrivers, coins, metal parts, etc.) or containers ﬁ lled with water on top of the camera. Doing so may cause personal injury due to ﬁ re, electric shock, or falling objects.

7.Do not install the unit in humid, dusty, or sooty locations. Doing so may cause ﬁ re or electric shock.

8.If any unusual smells or smoke come from the unit, stop using the product. In such case, immediately disconnect the power source and contact the service center. Continued use in such a condition may cause ﬁ re or electric shock.

9.If this product fails to operate normally, contact the nearest service center. Never disassemble or modify this product in any way. (SAMSUNG is not liable for problems caused by unauthorized modiﬁ cations or attempted repair.)

10.When cleaning, do not spray water directly onto parts of the product. Doing so may cause ﬁ re or electric shock

11.If the camera is installed or rebooted after power failure when ambient temperature is below the freezing point, the dome cover is frosted. In this case, the frost will be disappeared after 3 hours after turning on the power.

(It is noted that lowest guaranteed operating temperature is -45ºC(-49ºF) without wind.).

12.Do not expose the product to the direct airﬂ ow from an air conditioner.

Otherwise, it may cause moisture condensation inside the Clear Dome due to temperature difference between internal and external of the dome camera.

13.If you install this product in a low-temp area such as inside a cold store, you must seal up the wiring pipe with silicon, so that the external air can not ﬂ ow inside the housing.

Otherwise, external high, humid air may ﬂ ow inside the housing, pooling moisture or vapor inside the product due to a difference between internal and external temperature.

2 – 36x Network Smart Dome Camera