Airlink101 AICN1777W user manual Basic Setup, Basic System, Indication LED

Page 22

CHAPTER 4

USING WEB CONFIGURATION

You can access and manage the camera through the Web browser and the provided software application SkyIPCam UltraView. This chapter describes the Web Configuration, and guides you through the configuration of the camera by using the web browser.

To open the Web Configuration page, please refer to Chapter 3.2, Viewing Image via Your Camera.

After you entered into the Web Configuration of the camera, click Setup on the main page. The Web Configuration will start from the Basic page.

4.1 Basic Setup

The Basic menu contains three sub-menus that provide the system settings for the camera, such as the Camera Name, Location, Date & Time, and User management.

Basic >> System

Basic

-Camera Name: Enter a descriptive name for the camera.

-Location: Enter a descriptive name for the location used by the camera.

Indication LED

This item allows you to set the LED illumination as desired. The available options include: Normal, OFF, and Dummy. You can select OFF to turn off the camera’s LED signal in order to make it less noticeable, or you can select Dummy to leave the Link LED be on even when it is not connected to the network.

- 21 -

Image 22

Contents User’s Manual Technical Support Checking the Package Contents Chapter Introduction to Your CameraGetting to Know Your Camera Front ViewRear View GpioFeatures and Benefits Networking Accessing the Camera using Web BrowserSystem Requirements RAM 512MBChapter Hardware Installation Installing the Wall Mount KitConnecting the Camera to LAN/WLAN Applications of the Camera Chapter Camera Configuration Setting up Your CameraUltraView folder run Setup.exe Page Page Page IP Address Submask Page Page Method a Access Camera from SkyIPCam Utility Viewing Image via Your CameraPage Page Basic Basic SetupBasic System Indication LEDBasic User AdministratorBasic Date & Time Date & TimeGuest IP Setting Network SettingsNetwork Network UPnP Ddns SettingPorts Number Accept Network IP FilterDeny Network Wireless Setting WPA2-PSKPage Select PIN Mode Network Wireless WPS SettingSelect PBC Mode Recommended Pan/Tilt Settings Pan & Tilt Pan & Tilt SettingsImage Setting Setting up Video & AudioVideo & Audio Camera Video & Audio Video 3GPPCamera Microphone Video & Audio AudioCamera Speaker Out Event Server Setting FTP Event ServerEvent Server Setting Email Event Server Setting NAS Network StorageMotion Detect Event Configuration General Setting Event ConfigEvent Configuration Schedule Profile Event Configuration Motion Detect Trigger Event Configuration Schedule Trigger Event Configuration Gpio TriggerConfiguration Factory ResetSystem Reboot Update FirmwareUSB Dismount USBUSB Information 10 RS-485 About the Control Buttons Control Buttons of RS-485Information Device Info InformationInformation System Log Chapter Using Skyipcam Ultraview Starting the ProgramMain Window and Item Feature Talk On/Off. If the connected camera features speaker Number 1~8 from the Go button Accessing the Camera Adding a CameraPage TIP Close Page Editing / Deleting a Camera Viewing Image of the Camera Recording / Playing Video Enabling / Disabling RecordingConfiguring the Recording Settings Setting up Schedule for Recording Playback the Recording Files Configuring the eMap View Setting Page To view from eMap Page Editing / Deleting the eMap To view Camera StatusConfiguring the System User managementTo change the System Language To check the version number System Setting Event Configuration Setting up Event ServerSending Email Notification Configuring Event Trigger Terminating Operation Specification Interface Schematic Connector Pin AssignmentGpio Terminal Application Bandwidth Reference Guide MPEG4Glossary of Terms NumbersHEX LAN Smtp Technical Support