Airlink101 AICN1777W user manual Event Server Setting FTP

Page 35

4.5 Event Server

The Event Server menu contains three sub-menus that allow you to upload images to FTP, send emails that include still images, and store video clips, send still images to a NAS (network attached storage) device.

Event Server Setting>> FTP

￿FTP

-Host Address: Enter the IP address of the target FTP server.

-Port Number: Enter the port number used for the FTP server.

-User Name: Enter the user name to login into the FTP server.

-Password: Enter the password to login into the FTP server.

-Directory Path: Enter the destination folder for uploading the images. For example, /Test/.

-Passive Mode: Check the Enable box to enable passive mode. If you are having trouble, you can enable/disable this mode.

-FTP Upload with: Select upload to FTP with One Snapshot image or a series image in Pre- event/Post-eventtime when event triggered.

NOTE Due to the network environment, the camera may not upload number of images that you set.

When you complete the required settings for FTP, click Test to find out if the related configuration is correct or not. Once the camera connects to the server successfully, click Apply.

- 34 -

Image 35
Contents User’s Manual Technical Support Chapter Introduction to Your Camera Checking the Package ContentsFront View Getting to Know Your CameraGpio Rear ViewFeatures and Benefits RAM 512MB Accessing the Camera using Web BrowserSystem Requirements NetworkingInstalling the Wall Mount Kit Chapter Hardware InstallationConnecting the Camera to LAN/WLAN Applications of the Camera Setting up Your Camera Chapter Camera ConfigurationUltraView folder run Setup.exe Page Page Page IP Address Submask Page Page Viewing Image via Your Camera Method a Access Camera from SkyIPCam UtilityPage Page Indication LED Basic SetupBasic System BasicDate & Time AdministratorBasic Date & Time Basic UserGuest Network Network Network SettingsIP Setting Ports Number Ddns SettingUPnP Deny Network IP FilterAccept WPA2-PSK Network Wireless SettingPage Select PBC Mode Recommended Network Wireless WPS SettingSelect PIN Mode Pan & Tilt Pan & Tilt Settings Pan/Tilt SettingsVideo & Audio Camera Setting up Video & AudioImage Setting 3GPP Video & Audio VideoCamera Speaker Out Video & Audio AudioCamera Microphone Event Server Event Server Setting FTPEvent Server Setting Email Network Storage Event Server Setting NASMotion Detect Event Configuration Schedule Profile Event ConfigEvent Configuration General Setting Event Configuration Motion Detect Trigger Event Configuration Gpio Trigger Event Configuration Schedule TriggerUpdate Firmware Factory ResetSystem Reboot ConfigurationUSB Information USBUSB Dismount 10 RS-485 Control Buttons of RS-485 About the Control ButtonsInformation System Log InformationInformation Device Info Starting the Program Chapter Using Skyipcam UltraviewMain Window and Item Feature Talk On/Off. If the connected camera features speaker Number 1~8 from the Go button Adding a Camera Accessing the CameraPage TIP Close Page Editing / Deleting a Camera Viewing Image of the Camera Enabling / Disabling Recording Recording / Playing VideoConfiguring the Recording Settings Setting up Schedule for Recording Playback the Recording Files Configuring the eMap View Setting Page To view from eMap Page To view Camera Status Editing / Deleting the eMapUser management Configuring the SystemTo change the System Language To check the version number System Setting Setting up Event Server Event ConfigurationSending Email Notification Configuring Event Trigger Terminating Operation Specification Gpio Terminal Application Connector Pin AssignmentInterface Schematic MPEG4 Bandwidth Reference GuideNumbers Glossary of TermsHEX LAN Smtp Technical Support