Airlink101 AICN1777W user manual Connecting the Camera to LAN/WLAN

Page 9

2.2 Connecting the Camera to LAN/WLAN

Use the provided Ethernet cable to connect the camera to your local area network (LAN). When you connect the AC power adapter, the camera is powered on automatically. You can verify the power status from the Power LED on the front panel of the camera. Once connected, the Link LED starts flashing green light and the camera is on standby and ready for use now.

Connecting the Ethernet Cable

If you use a wireless network in your application environment, you need to attach the included external antenna to the camera. When the camera is powered on, the camera will automatically search any access point with “airlink101” SSID.

Connecting the External Antenna

NOTE If the camera cannot connect to your wireless network, you need to

first install the camera in LAN and then proceed with WLAN settings.

- 8 -

Image 9

Contents User’s Manual Technical Support Chapter Introduction to Your Camera Checking the Package ContentsFront View Getting to Know Your CameraGpio Rear ViewFeatures and Benefits System Requirements Accessing the Camera using Web BrowserNetworking RAM 512MBInstalling the Wall Mount Kit Chapter Hardware InstallationConnecting the Camera to LAN/WLAN Applications of the Camera Setting up Your Camera Chapter Camera ConfigurationUltraView folder run Setup.exe Page Page Page IP Address Submask Page Page Viewing Image via Your Camera Method a Access Camera from SkyIPCam UtilityPage Page Basic System Basic SetupBasic Indication LEDBasic Date & Time AdministratorBasic User Date & TimeGuest Network Settings IP SettingNetwork Network Ddns Setting UPnPPorts Number Network IP Filter AcceptDeny WPA2-PSK Network Wireless SettingPage Network Wireless WPS Setting Select PIN ModeSelect PBC Mode Recommended Pan & Tilt Pan & Tilt Settings Pan/Tilt SettingsSetting up Video & Audio Image SettingVideo & Audio Camera 3GPP Video & Audio VideoVideo & Audio Audio Camera MicrophoneCamera Speaker Out Event Server Event Server Setting FTPEvent Server Setting Email Network Storage Event Server Setting NASMotion Detect Event Config Event Configuration General SettingEvent Configuration Schedule Profile Event Configuration Motion Detect Trigger Event Configuration Gpio Trigger Event Configuration Schedule TriggerSystem Reboot Factory ResetConfiguration Update FirmwareUSB USB DismountUSB Information 10 RS-485 Control Buttons of RS-485 About the Control ButtonsInformation Information Device InfoInformation System Log Starting the Program Chapter Using Skyipcam UltraviewMain Window and Item Feature Talk On/Off. If the connected camera features speaker Number 1~8 from the Go button Adding a Camera Accessing the CameraPage TIP Close Page Editing / Deleting a Camera Viewing Image of the Camera Enabling / Disabling Recording Recording / Playing VideoConfiguring the Recording Settings Setting up Schedule for Recording Playback the Recording Files Configuring the eMap View Setting Page To view from eMap Page To view Camera Status Editing / Deleting the eMapUser management Configuring the SystemTo change the System Language To check the version number System Setting Setting up Event Server Event ConfigurationSending Email Notification Configuring Event Trigger Terminating Operation Specification Connector Pin Assignment Interface SchematicGpio Terminal Application MPEG4 Bandwidth Reference GuideNumbers Glossary of TermsHEX LAN Smtp Technical Support