Airlink101 AICN1777W user manual Usb, USB Dismount, USB Information

Page 43

4.9 USB

The USB menu provides the information and controls of the connected USB device.

USB Dismount

To safely remove the connected USB device, press the Dismount button for four seconds on the camera or click Dismount on this page.

USB Information

Display the Total space and Free space of the USB device.

USB Setting

-When Disk Full: Select Stop Recording or Recycle – Delete Oldest Folder of File when the storage space on the USB device is full.

NOTE The connected USB storage device can be used to store still images only and as your host system backup. It is not recommended to use the USB device as your major storage device.

- 42 -

Image 43

Contents User’s Manual Technical Support Chapter Introduction to Your Camera Checking the Package ContentsFront View Getting to Know Your CameraGpio Rear ViewFeatures and Benefits RAM 512MB Accessing the Camera using Web BrowserSystem Requirements NetworkingInstalling the Wall Mount Kit Chapter Hardware InstallationConnecting the Camera to LAN/WLAN Applications of the Camera Setting up Your Camera Chapter Camera ConfigurationUltraView folder run Setup.exe Page Page Page IP Address Submask Page Page Viewing Image via Your Camera Method a Access Camera from SkyIPCam UtilityPage Page Indication LED Basic SetupBasic System BasicDate & Time AdministratorBasic Date & Time Basic UserGuest IP Setting Network SettingsNetwork Network UPnP Ddns SettingPorts Number Accept Network IP FilterDeny WPA2-PSK Network Wireless SettingPage Select PIN Mode Network Wireless WPS SettingSelect PBC Mode Recommended Pan & Tilt Pan & Tilt Settings Pan/Tilt SettingsImage Setting Setting up Video & AudioVideo & Audio Camera 3GPP Video & Audio VideoCamera Microphone Video & Audio AudioCamera Speaker Out Event Server Event Server Setting FTPEvent Server Setting Email Network Storage Event Server Setting NASMotion Detect Event Configuration General Setting Event ConfigEvent Configuration Schedule Profile Event Configuration Motion Detect Trigger Event Configuration Gpio Trigger Event Configuration Schedule TriggerUpdate Firmware Factory ResetSystem Reboot ConfigurationUSB Dismount USBUSB Information 10 RS-485 Control Buttons of RS-485 About the Control ButtonsInformation Device Info InformationInformation System Log Starting the Program Chapter Using Skyipcam UltraviewMain Window and Item Feature Talk On/Off. If the connected camera features speaker Number 1~8 from the Go button Adding a Camera Accessing the CameraPage TIP Close Page Editing / Deleting a Camera Viewing Image of the Camera Enabling / Disabling Recording Recording / Playing VideoConfiguring the Recording Settings Setting up Schedule for Recording Playback the Recording Files Configuring the eMap View Setting Page To view from eMap Page To view Camera Status Editing / Deleting the eMapUser management Configuring the SystemTo change the System Language To check the version number System Setting Setting up Event Server Event ConfigurationSending Email Notification Configuring Event Trigger Terminating Operation Specification Interface Schematic Connector Pin AssignmentGpio Terminal Application MPEG4 Bandwidth Reference GuideNumbers Glossary of TermsHEX LAN Smtp Technical Support