Airlink101 AICN1777W user manual Event Configuration Motion Detect Trigger

Page 40

-Profile Name: Display the profile name that you select in the Schedule Profiles list.

-Weekdays: Select the weekday(s) that you want to separately assign in the schedule profile. The weekday that has been assigned will be displayed with green color.

-Time List: Display the time period that you have assigned within the selected weekday. To assign the same time period to every weekday, click Copy this to all weekdays; click Delete this from all weekdays to remove the selected time period from every weekday. Click Delete to remove the selected time period.

-Start/End Time: Enter the start and end time and then click Add to assign a time period within the selected weekday.

Event Configuration >> Motion Detect Trigger

Motion Detect Trigger: Check the Enable option to enable the trigger function of the camera, so that you can send captured images within the detecting area to the FTP server, email receiver, or the Network Storage server. You have to configure the corresponding settings, such as FTP or Email server under Event Server to allow these events to work properly. Please note that you have to configure the related settings before enabling these features.

-Schedule Profile: Select a schedule profile from the pull-down list.

-Action: Set the Trigger Out function or the following options: Record to Network Storage (video clips without audio), Send Email (captured images), or FTP Upload (captured images).

- 39 -

Image 40

Contents User’s Manual Technical Support Checking the Package Contents Chapter Introduction to Your CameraGetting to Know Your Camera Front ViewRear View GpioFeatures and Benefits Accessing the Camera using Web Browser System RequirementsNetworking RAM 512MBChapter Hardware Installation Installing the Wall Mount KitConnecting the Camera to LAN/WLAN Applications of the Camera Chapter Camera Configuration Setting up Your CameraUltraView folder run Setup.exe Page Page Page IP Address Submask Page Page Method a Access Camera from SkyIPCam Utility Viewing Image via Your CameraPage Page Basic Setup Basic SystemBasic Indication LEDAdministrator Basic Date & TimeBasic User Date & TimeGuest IP Setting Network SettingsNetwork Network UPnP Ddns SettingPorts Number Accept Network IP FilterDeny Network Wireless Setting WPA2-PSKPage Select PIN Mode Network Wireless WPS SettingSelect PBC Mode Recommended Pan/Tilt Settings Pan & Tilt Pan & Tilt SettingsImage Setting Setting up Video & AudioVideo & Audio Camera Video & Audio Video 3GPPCamera Microphone Video & Audio AudioCamera Speaker Out Event Server Setting FTP Event ServerEvent Server Setting Email Event Server Setting NAS Network StorageMotion Detect Event Configuration General Setting Event ConfigEvent Configuration Schedule Profile Event Configuration Motion Detect Trigger Event Configuration Schedule Trigger Event Configuration Gpio TriggerFactory Reset System RebootConfiguration Update FirmwareUSB Dismount USBUSB Information 10 RS-485 About the Control Buttons Control Buttons of RS-485Information Device Info InformationInformation System Log Chapter Using Skyipcam Ultraview Starting the ProgramMain Window and Item Feature Talk On/Off. If the connected camera features speaker Number 1~8 from the Go button Accessing the Camera Adding a CameraPage TIP Close Page Editing / Deleting a Camera Viewing Image of the Camera Recording / Playing Video Enabling / Disabling RecordingConfiguring the Recording Settings Setting up Schedule for Recording Playback the Recording Files Configuring the eMap View Setting Page To view from eMap Page Editing / Deleting the eMap To view Camera StatusConfiguring the System User managementTo change the System Language To check the version number System Setting Event Configuration Setting up Event ServerSending Email Notification Configuring Event Trigger Terminating Operation Specification Interface Schematic Connector Pin AssignmentGpio Terminal Application Bandwidth Reference Guide MPEG4Glossary of Terms NumbersHEX LAN Smtp Technical Support