Peavey manual Ecoustic E20 Acoustic Guitar Amplifier Specifications

Ecoustic® E20 Acoustic Guitar Amplifier Specifications

Rated Power & Load:

20 W(rms) into 4 ohms

Power @ clipping (typical):

(5% THD, 1 kHz, 120 VAC line)

20 watt RMS into 4 ohms

Total Harmonic Distortion:

Less than 0.5%, 100 mW to 12 watt RMS, 60 Hz to 10 kHz, 4 ohms (typically below 0.2%)

Power Consumption:

50 watts, 50/60 Hz, 120 VAC

Preamp Section:

The following specs are measured @ 1 kHz with the EQ flat

@0 dB. Nominal values are with levels @ 5, minium values are with levels @ 10.

Instrument Inputs:

Input impedance: 220 K ohms

Nominal input level: -4.5 dBV, 600 mV RMS

Minimum input level: -20.6 dBV, 93 mV RMS

Maximum input level: +12 dBV, 4 V RMS

Frequency response: +0, -2 dB, 50 Hz to 10 kHz

Headphone Output:

(Stereo headphone jack, mono signal) Load impedance: 4 ohms or greater Nominal power output: 20 mW into 4 ohms

(Switching jack disconnects the internal speaker when plug is inserted)

System hum and noise:

80 dBV (both channels operating)

Equalization (both channels)

15 dB @ 80 Hz and 8 kHz, shelving

Dimensions (H x W x D):

14.25"(362 mm) x13.75" (349 mm) x 9.0" (229 mm)

Weight:

17.4 lbs. (7.89 kg)

NOTE: Specifications subject to change without notice.

19