NEC RS-232C manual Model Name Read

12.2 Model Name Read

This command is used in order to read the Model Name. 1) The controller requests the monitor to read Model Name.

	Header			Message	Check code		Delimiter
	SOH-'0'-Monitor ID-'0'-'A'-'0'-'6'			STX-'C'-'2'-'1'-'7'-ETX	BCC		CR
	Header
	SOH (01h): Start Of Header
	'0' (30h): Reserved
	Monitor ID: Specify the Monitor ID which you want to get Model Name.
	Ex.) If Monitor ID is '1', specify 'A'.
	'0' (30h): Message sender is the controller.
	'A' (41h): Message type is "Command".
	'0'-'6'(30h, 36h): Message length
	Message
	STX (02h): Start of Message		31h, 37h): Model Name command
	'C'-'2'-'1'-'7' (43h, 32h,
	ETX (03h): End of Message
	Check code
	BCC: Block Check Code
	Refer to the section 4.5 “Check code” for a BCC calculation.
	Delimiter
	CR (0Dh): End of packet
	2) The monitor replies the model name data to the controller.
	Header			Message		Check code		Delimiter
SOH-'0'-'0'-Monitor ID-'B'-N-N		STX-'C'-'3'-'1'-'7'-Data(0) -Data(1)—---				BCC		CR
		-Data(n)-ETX
	Header
	SOH (01h): Start Of Header
	'0' (30h): Reserved
	'0' (30h): Message receiver is the controller.
	Monitor ID: Indicate a replying Monitor ID.
	Ex.) When this byte is set to 'A', the replying Monitor ID is '1'.
	'B' (42h): Message type is "Command reply".
	N-N: Message length
	Note.) The maximum data length that can be returned from the monitor at a time is
	32bytes.
	Ex.) The byte data 20h is encoded as ASCII characters '2' and '0' (32h and 30h).
	Message
	STX (02h): Start of Message
	'C'-'3'-'1'-'7' (43h, 33h, 31h, 37h): Model Name reply Command
	Data(0) -Data(1)----Data(n):Model name

These data are encoded to ASCII characters strings. ETX (03h): End of Message

Check code

BCC: Block Check Code

Refer to the section 4.5 “Check code” for a BCC calculation.

Delimiter

CR (0Dh): End of packet

(67/72)