Sennheiser EMP 2015 manual Connecting external audio devices

2 mono audio devices

1 stereo audio device

2 stereo audio devices

Connecting external audio devices

You can connect two mono or two stereo audio devices to the amplifier.

￿Connect the RCA plugs of the sound recording devices to the RCA sockets

(LINE IN) at the rear of the EMP 2015. For correct connection of the different audio devices, please refer to the diagrams at the left.

Note:

Stereo (left-right) signals are mixed in the amplifier and are then available as a mono signal.

￿If possible, set stereo audio devices to “mono” operation. If sound problems occur, use the left channel of TVs and VCRs.

Adjusting the volume of an external audio device

You can adjust the volume of the connected audio device (e.g. VCR) separately from the volume of the speaker’s microphone. If, however, you have connected two audio devices to the line input, the volume control adjusts the volume of both devices.

￿ Use the volume control (LINE IN)	to adjust the volume of the
connected device.

Note

If the audio signal sounds distorted, reduce the sensitivity of the system with control . If control is turned counterclockwise as far as possible, the audio signal may not be audible.

51