Sennheiser EMP 2015 manual Battery status indication, Bargraph, Red LED, Peak indication

Battery status indication

The red LED and the 8-segment bargraph on the display provide information on the battery status.

Bargraph:

The bargraph indicates the (remaining) battery capacity in 3 steps:

8 segments: the full battery capacity is available,

4 segments: the battery capacity is sufficient,

1 segment: the battery is going flat, immediately replace the battery.

Note:

When turning on the transmitter with a partially used battery, it is possible that all eight segments may show for a short period of time – if this happens, re-check battery status after a few moments.

Red LED:

Red LED lit up:The transmitter is turned on and the battery capacity is sufficient.

Red LED starts flashing: The battery is going flat! You should immediately replace the battery.

Peak indication
The yellow LED	at the top of the SK 500 transmitter lights up if the

audio signal at the microphone/line input is excessively high (AF PEAK).

Note:
The sensitivity of the microphone/line input	can be adjusted via the
operating menu ( “Adjusting the sensitivity”).

50