Sennheiser EMP 2015 manual Connecting an EM 500 receiver

EMP 2015 with three transmitters and two additional receivers

Installing a system including several transmitters (team teaching)

With one Soundfield System, up to three speakers can speak simultaneously in the same room.

Transmitter 1 is directly received by the receiver section of the EMP 2015. Transmitters 2 and 3 require an additional receiver respectively. The receivers can be connected to the RCA sockets (LINE IN) of the EMP 2015. The signals of all transmitters are then reproduced by the loudspeakers.

For installing the system described above, you require additional SK 500 bodypack transmitters and EM 500 rack-mount receivers ( “Recommended accessories”).

Connecting an EM 500 receiver

For connecting an EM 500 receiver, you require a connecting cable fitted with an 1/4” (6.3 mm) jack plug and an RCA plug ( “Recommended accessories”).

￿Prepare the receiver for use as described in the receiver’s instruction manual.

￿Connect the RCA plug of the connecting cable to one of the two RCA

sockets (LINE IN) of the EMP 2015.

￿Connect the 1/4” (6.3 mm) jack plug of the connecting cable to the 1/4” (6.3 mm) jack socket of the receiver.

￿Set the transmitter and receiver of each transmission link to the same frequency.

Note:

Transmitter and receiver of each transmission link have to operate on the same frequency which must differ from the frequencies used by other transmission links in the room. With both the transmitter and receiver of the Soundfield System and the additional S K 500 transmitters and EM 500 receivers you can change the frequencies and store them in one of the 16 fixed frequency memories ( “Operating steps for configuring a frequency memory”).

Adjusting the volume of the connected receivers

￿ Use the volume control (LINE IN)	to adjust the volume of the
connected receiver.

Note:

If you have connected two receivers to the line input, the volume control adjusts the volume of both receivers.

56