6.1 Switching on and off
>Switch the receiver on by pressing the On/Standby key, either on the receiver itself or on the remote control unit.
>Pressing this key again on the receiver or on the remote control will switch the receiver off again.
>The receiver is now in standby mode, and the display on the receiver box front panel will show the time. If the time is not displayed, this must still be entered into the unit. To do this, switch the receiver on, and switch to reception of any major channel, such as ZDF, to enter the time automatically.
6.2 Programme Selection
6.2.1 Using the Programme up/down keys
>You can use the Programme up/down keys on the receiver or on the remote control to move up or down the programme list one slot at a time.
6.2.2 Using the numeric keypad
>Simply enter the desired programme number via the
numeric keypad. |
|
For example: |
|
1 | for programme slot 1 |
1, then 4 | for programme slot 14 |
2, then 3, then 4 for programme slot 234
When entering programme numbers with more than one digit, you have approx. 3 seconds after entering a number to continue to the next digit. If you wish to enter a programme number with only one or two digits, you can speed up the switching process by holding down the last number a little longer.
6.2.3 Using the programme list
>Press the OK key.
The programme list will now be displayed. (Fig.
>You can now use the arrow keys up/down to
highlight the desired programme. | (Fig. |
|
>Press the OK key to select the highlighted programme.
>Use the arrow keys up/down to scroll through the list one line at a time.
>Use the arrow keys left/right to scroll quickly through the list one page at a time.
17