TechniSat DigiPal1 manual For everyday use, Volume adjustment, Switching on and off

For everyday use

Switching on and off

>Switch the receiver on by pressing the On/Standby key, either on the receiver unit itself or on the remote control.

>Press the key again either on the receiver unit or on the remote control to switch the receiver off again.

>The receiver is now in Standby mode.

Programme selection

Using the Programme up/down keys

>Use the Programme up/down either on the receiver unit itself or on the remote control to switch the programmes up or down the programme list one position at a time.

Using the numeric keypad

>Use the numeric keypad to enter the desired

programme number.

For example
1	for programme slot 1
1, then 4	for programme slot 14

2, then 3, then 4 for programme slot 234

When entering programme numbers with more than one digit you have approx. 3 seconds time after pressing a key to enter the next digit and complete the entry.

If you wish to enter only a single or double-digit number, you can speed up the switching procedure by holding down the key when you enter the last digit.

Volume adjustment

>You can adjust the volume of your receiver by pressing the Volume + key to make the sound louder, or the Volume - key to make it softer.

>Press the key Sound on/off to mute the sound, press the key again to switch the sound back on.

TV/Radio switching

The pre-programming of your receiver covers radio as well as television programmes. In Radio mode, the corresponding TV picture is switched off, and only the programme name is displayed on screen.

>Press the TV/Radio key to switch the receiver to Radio mode.

The receiver will now switch automatically to the last radio programme selected.

>Press the key TV/Radio again to return to the television programme last selected.

38