Power does not turn on.
(No sound is produced.)
No sound output when operating the unit with amplifiers.
Incorrect wiring.
Amplifier
The microprocessor has malfunctioned due to noise, etc.
Replace with a fuse of the same amperage. If the fuse blows again, consult your store of purchase.
Consult your store of purchase.
Turn the unit off and check each wire for a possible short. If the amplifier
Open the front panel |
| |
by pressing the | Reset | |
[OPEN] button. Press | ||
button | ||
the reset button for | ||
| ||
about 2 seconds with a |
| |
thin rod. |
| |
The settings will |
| |
remain in the ROM |
| |
even if you press the |
| |
reset button. |
|
The speaker protection circuit is operating.
The settings in the ROM failure. ROM are not
stored properly.
Disc does not start. The unit is not turned on.
There is a disc other than a compact disc or foreign matter already in place.
MP3IWMA files are absent in a disc.
1.Check the speaker connection.
2.Turn down sound volume. Function can also be restored by turning the power off and on again.
3.If the sound is muted again, consult your store of purchase.
If the error persists, consult your store of purchase.
Turn the power on.
Press the [~] button to eject.
Write MP3IWMA files onto the disc properly.
Files are not recognized Use MP3IWMA files encoded properly. as an MP3IWMA file.
File system is not correct. Use 1809660 level 1,2 or JOLIET or Romeo file system.
Disc is dirty. | Clean the disc with a soft cloth. |
Disc is heavily scratched Replace with a disc with no scratches. or warped.
CM05 33