If an error occurs, one of the following displays is displayed. Take the measures described below to eliminate the problem.
A DISC is caught inside the CD deck and is not ejected.
This is a failure of CD deck'smechanism and consult your store of purchase.
A DISC cannot be played due to scratches, etc.
ADISC is loaded upside- down inside the CD deck and does not play.
A communication error occu rs between the iPod and the iPod CeNET Controller.
Replace with a
Eject the disc then reload it properly.
Disconnect the iPod, then connect it again.
A CD inside the CD changer is not loaded.
ACD inside the CD changer cannot be played due to scratches, etc.
A CD inside the CD changer cannot be played because it is loaded
The speaker protection circuit is operating. During this operation, if any volume operation is performed, the display shows "AMP GUARD". "AMP GUARD" sometimes functions when special test signals are used.
This is a failure of CD changer'smechanism. Consult your store of purchase.
Replace with a
Eject the disc, then reload it properly.
1.Turn down sound volume. Function can also be restored by turning the power off and on again.
(Speaker volume is reduced automatically when the speaker protection circuit operates.)
2.If the sound is muted again, consult our service department.
If an error display other than the ones described above appears, press the reset button. If the problem persists, turn off the power and consult your store of purchase.