TOA Electronics VM-2120 Remote Microphones Function Switches, Connected unit No. table SW3

Connected unit No. table (SW3)

	Switch No.			No. of Connected Units*
6		7	8
OFF		OFF	OFF	0
ON		OFF	OFF	1
OFF		ON	OFF	2
ON		ON	OFF	3
OFF		OFF	ON	4
ON		OFF	ON	5

*The total number of one Sub-VM amplifier and up to 4 Remote Microphones (excluding the Master amplifier and Remote Microphone Extension)

SW4 switch setting (Both switches are factory-preset to ON position.)

Switch No.		BGM broadcast volume attenuation*
1	2
OFF	OFF	No attenuation
	ON	–28 dB (just audible)
ON	Don't care	– ∞ dB (inaudible)

*Determines the attenuation level when the broadcast of higher priority (level 2 or 3) overrides the BGM broadcast (priority level 4). (See p.27 "GENERAL-PURPOSE BROADCAST PRIORITY)

23.3. Remote Microphone's Function Switches

1 2 3 4 5 6 ON

Note

Function setting switch (No.23) The switch is actually installed upside down.

Switch No.	1	2	3	4	5	6
Function	RM Unit No.		Broadcast	Talk key	Emergency	Compressor
	(See the RM Unit No.		Priority*	operation	switch
ON	table below.)		2	Press-to-talk	Enable	On
				type
OFF			1	Talk lock type	Disable	Off

*One of 2 priorities can be set for each Remote microphone. (See p.27 "GENERAL-PURPOSE BROADCAST PRIORITY.")

RM (RM-200M) Unit No. table

Switch No.		RM Unit No.
1	2
ON	ON	No. 1
OFF	ON	No. 2
ON	OFF	No. 3
OFF	OFF	No. 4

All switches No. 1 – 6 are factory-preset to the ON position.

50