TOA Electronics VM-2120 instruction manual Recorded Message-to-Group Assignment Operation

24.5. Recorded Message-to-Group Assignment Operation

Here, the operation example of assigning Recorded Message 1 to Broadcast Groups 1, 3, and 4 will be explained. (See p. 52 "Message 1 to group" setting example.)

Step 1. Entry to recorded message setting mode

ZONE 1 ZONE 3 Reset

Press and release the Reset key while holding down the ZONE 1 and ZONE 3 keys. When all indicators for Zones 1 – 5 begins to flash (2 – 3 seconds after), release both the ZONE 1 and ZONE 3 keys.

Message 1 Message 5

The unit will be placed in recorded message setting mode.

The 5 indicators for ZONE 1 through ZONE 5 begin to flash. (They indicate Message 1 through Message 5.)

ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL

Operations of Steps 2 – 6 described hereafter are the same as those described in the previous section Control input/Telephone paging/Westminster chime-to-Group assignment. However, read 5 setting items of Inputs 1 – 3, TEL paging, and Westminster chime as Messages 1 – 5.

Group 1	Group 5
(Message 1)
Shown on the right is the status of each indicator that results
from the group number setting (Example. Groups 1, 3, and 4)
performed in Step 4.

ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL

58