Message setting contents check | TOA Electronics VM-2120 specification

Step 4. Group number setting (Example: Groups 1, 2, and 3)

4-1.Pressing the ALL key will cancel the "ALL zones" setting, causing the ALL indicator and the indicators for ZONES 2 – 5 to flash. The ZONE 1 indicator changes from "slow flashing" to "quick flashing," indicating that Input 1 was selected but Group 1 was not.

Note: The setting returns to the situation before the "ALL zones" was set.

4-2.Press the ZONE 1, ZONE 2, and ZONE 3 keys to select the Groups 1 through 3.

•The ZONE 1 indicator changes from "quick flashing" to "slow flashing*," indicating that Input 1 was selected and that Group 1 was set.

•Indicators for ZONE 2 and ZONE 3 become steadily on. (This represents that Groups 2 and 3 are selected.)

•Indicators for ZONE 4, ZONE 5, and ALL remain flashed. (This represents that Groups 4 and 5 were not selected.)

Step 5. Programming of the group number setting

Press the POWER switch.

The Groups 1, 2, and 3 will then be programmed, automatically returning the procedure to Step 2. According to the instructions in Step 2, set the next setting item. (Repeat Steps 2 through 5.)

Step 6. Setting completion

After completing all item settings, press the Reset key using a pointed object.

This completes the setting mode, returning the unit to broadcast standby mode.

* See p. 55 Indicator status.

[Message setting contents check]

Group 1						Group 5
(Input 1)
(Input 1)

ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL

Group 1						Group 5
(Input 1)
(Input 1)

ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5

ALL

POWER

Reset

Complete Steps 1, 2, and 3, then jump to Steps 5 and 6 without executing Step 4 (group number setting).

[Operation for group selection and its cancellation]

•Pressing a currently flashing or quickly flashing zone key for any group not selected will select that group (the zone indicator then remains steadily lit or slowly flashes).

•Conversely, if a currently selected zone key is pressed, that group will then be deselected. ("Selected" and "deselected" states are alternately changed with each press of the key.)

[Dual indication of setting item and group selections]

The indicators for set groups remain steadily on, while those for unset groups flash. However, if a group to which the setting item is assigned as in the figure of Step 2 is selected, the corresponding indicator slowly flashes*. (This provides a dual indication of Setting item and Group selection.) When that group is not selected, the indicator quickly flashes*. (This provides a dual indication of Setting item selection and Group deselection.)

* See p. 55 Indicator status.