Pioneer FH-P800BT Pairing a connected cellular phone, Disconnecting a cellular phone

2Turn MULTI-CONTROL to select

PAIRED PHONE.

# Push MULTI-CONTROL up or down to select a

desired phone.

# Push MULTI-CONTROL left or right to display the BD address, group and ID number.

3Press MULTI-CONTROL to start connec- tion.

PIN code is set to 0000 as the default. You can change this code in the initial setting. Refer to Entering PIN code for Bluetooth wireless con- nection on page 51.

While connecting, CONNECTING is displayed. If the connection is established, CONNECTED is displayed.

After connected, this unit automatically changes to PH.BOOK DL (phone book down-

load confirmation) display.

# If the connection fails, ERROR is displayed. In this case, check the cellular phone and try again.

4Use MULTI-CONTROL to decide to download the phone book from your cellu- lar phone or not.

Push MULTI-CONTROL left or right to select NO (No) or YES (Yes).

Press MULTI-CONTROL to decide.

When you select YES, this unit changes to

PH BOOK DOWNLOAD and the download op- eration automatically begins. After complet-

ing, DATA DOWNLOADED is displayed.

# When you select NO, the display reverts to normal.

Pairing a connected cellular phone

Pairing is usually performed automatically dur- ing the connection operation. You only need to perform this operation manually when your phone is connected temporarily for any reason. We recommend you pair the phone to this unit to make best use of the technology.

1 Display the connection menu.

Refer to Introduction to connection and pairing on page 30.

2Use MULTI-CONTROL to select

SET PHONE.

3Push MULTI-CONTROL up or down to select a pairing assignment.

P1 (user phone 1)—P2 (user phone 2)—P3

(user phone 3)

# Push MULTI-CONTROL left or right to switch

the BD address and device name.

# If a phone is already assigned to the user phone number, the new phone will overwrite the

old one.

# As you select each assignment, you can see whether or not a phone is already paired. If the assignment is empty, NO DATA is displayed.

4Press MULTI-CONTROL to pair the cur- rently connected phone.

When pairing is completed, COMPLETED is

displayed.

# If the pairing fails, REGISTER ERROR is dis- played. In this case, return to step 1 and try again.

Operating this unit

Disconnecting a cellular phone

1 Display the connection menu.

Refer to Introduction to connection and pairing on page 30.

2Use MULTI-CONTROL to select

DISCONNECT PHONE.

3Press MULTI-CONTROL to disconnect a cellular phone from this unit.

After disconnection is completed, DISCONNECTED is displayed.

Deleting a paired phone

1 Display the connection menu.

Refer to Introduction to connection and pairing on page 30.

2Use MULTI-CONTROL to select

DELETE PHONE.