Pioneer FH-P800BT Initial Settings Activating the BT Audio source, Editing device name

Activating the BT AUDIO source

You need to activate the BT AUDIO source in order to use a Bluetooth audio player.

1Display the initial setting menu. Refer to Adjusting initial settings on page 48.

2Use MULTI-CONTROL to select

BT AUDIO.

3Press MULTI-CONTROL to turn the

BT AUDIO source on.

# To turn the BT AUDIO source off, press MULTI-CONTROL again.

Entering PIN code for Bluetooth wireless connection

To connect your cellular phone to this unit via Bluetooth wireless technology, you need to enter PIN code on your phone to verify the connection. The default code is 0000, but you can change this in this function.

!With some Bluetooth audio players, you may be required to enter the Bluetooth audio player PIN code in advance to set this unit for a connection.

1Display the initial setting menu. Refer to Adjusting initial settings on page 48.

2Use MULTI-CONTROL to select

PIN CODE INPUT.

3Push MULTI-CONTROL up or down to select a number.

4Push MULTI-CONTROL left or right to move the cursor to the previous or next po- sition.

5After inputting PIN code (up to 16 di- gits), press MULTI-CONTROL.

PIN code can be stored in memory.

When you press MULTI-CONTROL again on the same display, the PIN code you entered is stored in this unit.

#Pushing MULTI-CONTROL right in the confir- mation display returns you to the PIN code input display, and you can change the PIN code.

#If an invalid character has been entered in the

beginning, PIN code cannot be stored in mem- ory.

Editing device name

You can edit the device name.

The device name is set to PIONEER W-DIN BT as default.

1Display the initial setting menu. Refer to Adjusting initial settings on page 48.

2Use MULTI-CONTROL to select

EDIT DEVICE NAME.

3Press DISP to select the desired charac- ter type.

Press DISP repeatedly to switch between the following character types: Alphabet—Numbers

4Push MULTI-CONTROL up or down to select a letter of the alphabet.

5Push MULTI-CONTROL left or right to move the cursor to the previous or next character position.

6Move the cursor to the last position by pushing MULTI-CONTROL right after enter- ing the device name.

Push MULTI-CONTROL right again to store

the device name in memory temporarily.

# Pressing MULTI-CONTROL can also store the device name in memory temporarily. In this meth-

od, cursor doesn’t need to be the last position.

# If an invalid character has been entered, sub-

sequent characters are not displayed.

# If an invalid character has been entered in the

beginning, device name cannot be stored in memory.

Initial Settings