![](/images/new-backgrounds/1262584/26258497x1.webp)
| Section |
Initial Settings | 04 |
|
|
Note
You can match the clock to a time signal by pressing
!If 00 to 29, the minutes are rounded down. (e.g., 10:18 becomes 10:00.)
!If 30 to 59, the minutes are rounded up. (e.g., 10:36 becomes 11:00.)
Switching the auxiliary setting
Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 53.
1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.
2Use
3Press
AUX2 on.
# To turn AUX off, press
Switching the dimmer setting
To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can turn the dimmer on or off.
1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.
2Use
3Press
on.
# To turn dimmer off, press
Setting the rear output and subwoofer controller
This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (REAR SP :FULL) or subwoofer (REAR SP :S/W) connection. If you switch the rear output setting to REAR SP :S/W, you can connect a rear speaker lead directly to a sub- woofer without using an auxiliary amp. Initially, the unit is set for rear
1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.
2Use
S/W CONTROL.
3Press MULTI-CONTROL to switch the rear output setting.
Pressing
be displayed.
# When no subwoofer is connected to the rear output, select REAR SP :FULL
er).
# When a subwoofer is connected to the rear output, select REAR SP :S/W (subwoofer).
Notes
!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 46).
!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.
!Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this setting.
Initial Settings
En 49