Section
03Operating this unit
1Touch CLOCK ADJ on the system menu.
2Touch ON/OFF to turn the clock display
on.
# To turn the clock display off, touch ON/OFF again.
3Touch c or d to select the segment of the clock display you wish to set.
Each time you touch c or d it will select one segment of the clock display:
As you select segments of the clock display the segment selected will be highlighted.
4Touch a or b to put a clock right.
Notes
!You can match the clock to a time signal by touching JUST.
—If 00 to 29, the minutes are rounded down. (e.g., 10:18 becomes 10:00.)
—If 30 to 59, the minutes are rounded up. (e.g., 10:36 becomes 11:00.)
!Even when the sources are off, the clock dis- play appears on the display.
Setting for rear view camera (back up camera)
CAUTION
Pioneer recommends the use of a camera which outputs mirror reversed images, other- wise screen image may appear reversed.
This unit features a function that automatically switches to the rear view camera video (REAR CAMERA IN jack) when a rear view camera is installed on your vehicle. When the gear shift is in REVERSE (R) position, the video auto- matically switches to a rear view camera video. (For more details, consult your dealer.)
!After you set up the rear view camera set- ting, move the gear shift in REVERSE (R) and confirm if a rear view camera video can be shown on the display.
!If the display should be switched to a rear view camera video by error while you are
driving forward, change the rear view cam- era setting.
!To end watching a rear view camera video and return to the source display, press and hold VOLUME/MUTE.
!Even while driving, rear view camera image can be displayed. To do this, touch REARVIEW source icon. In this case, touch REARVIEW again to turn off the rear view camera. For details, refer to Selecting a source on page 16.
%Touch CAMERA POLARITY on the sys- tem menu to select an appropriate setting.
!BATTERY – When the polarity of the con- nected lead is positive while the gear shift is in REVERSE (R) position
!GROUND – When the polarity of the con- nected lead is negative while the gear shift is in REVERSE (R) position
!OFF – When a rear view camera is not con- nected to this unit
Adjusting the LCD panel slide position
You can adjust the LCD panel slide position so that the panel is set back or forward.
1Touch NEXT on the system menu.
2Touch FLAP SET BACK to turn the set back on.
The LCD panel slides to the back.
# Touch FLAP SET BACK again to turn the set back off and the LCD panel slides to the front.
Setting the automatic open function
To prevent the display from hitting the shift lever of an automatic vehicle when it is in P (park) position, or when you do not wish the display to open/close automatically, you can set the automatic open function in the manual mode.
1 Touch NEXT on the system menu.
46 En