
Appendix

Additional Information
iPod is not charged but operates correctly
Check if the connection cable for iPod shorted out (e.g., not caught in metal ob- jects). After checking, turn the ignition switch OFF and back ON or disconnect the iPod and connect again.
Error has occurred when connect- | Reconnect the iPod. |
ing the iPod to this unit | Turn the ignition switch to OFF, then to ACC |
| or ON. |
| Update the iPod version. |
|
|
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto TA and EQ, an error message may appear on the display. If an error message appears, refer to the table below to see what the problem is and the suggested method of correcting the problem. After checking, try again.
Message | Cause | Action |
|
|
|
Error. Please check MIC. | Microphone is not connected. | Plug the supplied microphone securely into |
|
| the jack. |
|
|
|
Error. Please check front SP., | The microphone cannot pick up the | ! Confirm that the speakers are connected |
Error. Please check FL SP., | measuring tone of a speaker. | correctly. |
Error. Please check FR SP., |
| ! Correct the input level setting of the power |
Error. Please check center SP., |
| amp connected to the speakers. |
Error. Please check rear SP., |
| ! Set the microphone correctly. |
Error. Please check RL SP., |
|
|
Error. Please check RR SP., |
|
|
Error. Please check subwoofer |
|
|
|
|
|
Error. Please check noise. | The surrounding noise level is too | ! Stop your car in a place that is as quiet as |
| high. | possible, and switch off the engine, air condi- |
|
| tioner or heater. |
|
| ! Set the microphone correctly. |
|
|
|
88
En