Adjusting the speaker output levels

Section

04Available accessories

Note

When playing a 2-channel mono source with Pro Logic turned on, there may be occasions when the following will occur:

!No audio is outputted if the center speaker setting is SMALL or LARGE and no center speaker is installed.

!Audio is heard only over the center speaker if installed and the center speaker setting is SMALL or LARGE.

Speaker level can be adjusted finely by listen- ing to an audio output. First, use test tone to adjust the approximate speaker level, and then use this function to adjust finely.

1Touch NEXT on the DSP function menu.

2Touch SPEAKER LEVEL.

3Touch a or b to select the speaker to be adjusted.

Each time you touch a or b selects the speak- er in the following order:

FRONT L (front speaker left)—CENTER (center speaker)—FRONT R (front speaker right)— REAR R (rear speaker right)—REAR L (rear

speaker left)—SUB WOOFER (subwoofer)

# You cannot select speakers whose size is set at OFF. (Refer to Setting the speaker setting on the previous page.)

4Touch c or d to adjust the speaker out- put level.

Each time you touch c or d increases or de- creases the speaker output level. +10 to –10 is displayed as the level is increased or de- creased.

Note

Selecting a cross-over frequency

You can select a frequency, under which sounds are reproduced through the subwoo- fer. If the installed speakers include one whose size has been set to SMALL, you can select a frequency, under which sounds are repro- duced through a LARGE speaker or subwoo- fer.

1Touch NEXT on the DSP function menu.

2Touch CROSS OVER.

3Touch a or b to select the speaker to be adjusted.

Each time you touch a or b selects the speak- er in the following order:

FRONT (front speakers)—CENTER (center speaker)—REAR (rear speakers)—

SUB WOOFER (subwoofer)

4Touch c or d to select cross-over fre- quency.

Each time you touch c or d selects cross-over frequencies in the following order: 63Hz—80Hz—100Hz—125Hz—160Hz— 200Hz

Note

Selecting a cross-over frequency is to set a cross- over frequency of the subwoofer’s L.P.F. (low-pass filter) and that of the SMALL speaker H.P.F. (high- pass filter). The cross-over frequency setting has no effect if the subwoofer is set to OFF and other speakers are set to LARGE or OFF.

Adjusting the speaker output levels using a test tone

This function allows you to easily get the over- all balance right among the speakers.

1 Touch NEXT on the DSP function menu.

To adjust the speaker output levels in this mode is	2 Touch TEST TONE.
the same as making the speaker output levels at
TEST TONE. Both provide the same results.

78 En