| Section |
Available accessories | 04 |
|
|
LOW
7Touch b and then touch c or d to se- lect the center frequency of selected band. Touch c or d until the desired frequency ap- pears in the display.
8Touch b and then touch c or d to ad- just the equalizer level.
Each time you touch c or d it increases or de- creases the equalizer level. +12 to
9Touch b and then touch c or d to se- lect the desired Q factor.
Each time you touch c or d switches between the following Q factor:
NARROW
# You can adjust parameters for each band of the other speakers in the same way.
Note
You can select a center frequency for each band. You can change the center frequency in
Using the auto-equalizer
The
You can turn the
1Touch NEXT twice on the DSP function menu.
2Touch AUTO EQ.
#You cannot use this function if auto TA and EQ has not been carried out.
3Touch d to turn the
# To turn
Auto TA and EQ (auto-time alignment and auto-equalizing)
The
The
WARNING
To prevent accidents, never carry out auto TA and EQ while driving. When this function measures the car interior acoustic characteristics to create an
CAUTION
!Carrying out auto TA and EQ under the follow- ing conditions may damage the speakers. Be sure to check the conditions thoroughly be- fore carrying out auto TA and EQ.
—When speakers are incorrectly connected. (e.g., When a rear speaker is connected to a subwoofer output.)
—When a speaker is connected to a power amp delivering output higher than the speaker’s maximum input power capabil- ity.
!If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in a drain on battery power. Be sure to place the microphone in the specified loca- tion.
Available accessories
En 81