Blaupunkt TCM 169 On/off Volume, Switching the unit on/off with the KeyCard, Altering the volume

Page 12

Quick reference for operating the radio, tape deck and CD changer (optional)

1On/off Volume

To switch the Radiophone on, press the knob (volume control).

A valid KeyCard or SIM card must be inserted in the unit already or within the next 15 seconds.

Switching the unit on/off with the KeyCard:

If the equipment has been switched on by pressing knob 1, then it can be switched off and on again with the KeyCard or SIM card.

This assumes that the program has been switched to “MENU” under “LEARN MODE” in the DSC menu.

Note:

Be sure to read the information in the section on “KeyCard/SIM card anti- theft protection system”.

Switching the unit on/off via the ig- nition:

If the equipment has been connected properly, it can be switched on and off with the vehicle ignition.

When the ignition has been switched off, the unit will emit a double beep to remind you to remove the KeyCard/ SIM card before leaving your vehicle. If you switch off the ignition during a telephone call, the Radiophone will re- main switched on until you have com- pleted the call.

Switching the radio on when the ig- nition is switched off

When the ignition is switched off (card is inserted) the equipment will continue to function as follows:

After you hear the double beep, press the knob. The equipment will switch back on. After one hour’s playing time, the Radiophone will switch off auto- matically to prevent the car battery from going dead.

Operation in combination with an ignition timer

If the ignition timer has been activated in the DSC mode, the Radiophone will switch off as programmed after the ig- nition is switched off (refer to the sec- tion on “Programming with DSC - IGNI-

TION TIMER”.

Altering the volume

Turn the knob to alter the volume. The setting will appear in the display. When the Radiophone is switched on, it will play at a preset volume (VOL- UME FIX).

VOLUME FIX can be altered as de- sired (refer to “Programming with DSC - VOLUME FIX”).

The volume can also be altered using the remote control (optional) by press- ing V- / V+.

76

Image 12

Contents Monte Carlo TCM Remote control RCT 07 optional Contents Radio, Cassette, Changer Option Contents Telephone Safety standards Safety informationImportant information General informationUsing the telephone while driving Using the telephone in critical areasImportant information Emergency callsInstallation AccessoriesGuarantee International telephone informa- tionKeyCard and SIM card Basic informationStarting up the Radiophone Training or replace KeyCard/ SIM card using DSC KeyCard and SIM cardRemoving the KeyCard/SIM card Train KeyCard/SIM cardsDSC learn mode Displaying the radio pass dataOptical warning of anti-theft protection Care of your KeyCard/SIM cardOn/off Volume Switching the unit on/off with the KeyCardSwitching the unit on/off via the ig- nition Switching the radio on when the ig- nition is switched offTrack switch SRC SourceTS / BND Eject cassetteCassette loading slot Storing radio stationsRecalling stored radio stations -Se AF / #= MIX DisplayRadio operation a Cassette operation Changer operation optionalTape operation Flashing card tongueStop this function by pressing or the opposite button Additional rocker switch functions Additional settings possible with AUDDSC mode C ME Unit Corresponding function must be activatedAudio mode AF Alternative FrequencyREG regional programme Radio, tape deck, CD changer optional, auxiliary sourceStation tuning Radio operation with RDS Radio Data SystemEntering the frequency directly Selecting a wavebandScrolling through the broadcast- ing networks FM only Storing radio stationsSelecting the seek-tuning sensi- tivity Switching from stereo to mono FM onlyRecalling stored radio stations Switching traffic announcement priority on/off Automatic seek tuning startSwitching off the beep tone Traffic programme station reception with RDS-EONOperating the cassette deck Operating the cassette deck Tape equalisationDolby B NR Care instructionsSwitching CD changer operation on CD changer operation optionalSelecting the CD and the track Cancel SelectAlter Store= ignition timer switched off Programming with DSC Radio, Cassette, Changer optionalMusic/voice is switched off Cards can only be programmed with the help of the DSC menuOn All of the menu items are available You can choose among the following oper- ating modes End DSC programming/save changesOverview of the DSC default settings Telephone operation Operating the telephone PIN codeInserting the SIM card/ entering your PIN code Reactivating the SIM cardOperating the telephone Making your first telephone callGSM emergency calls Do not hang up until you are told to do soQuick reference for using the telephone VolumeOn/Off Selection buttonsEnter PIN code Setup menu/Call menu To switch back to the telephone mode Press brieflyDisplays Radio menu Telephone-book menu@ Rocker switch Using the telephone GSM network service areaSwitching to telephone mode Save telephone numbers and namesUsing the telephone Dialling a telephone numberRedial function Answering/ending a callAutomatic Save telephone numbers from the note- padCall waiting 2nd caller Broker’s call/holdMaking telephone calls using the handset special accessory Setting up a conference callConference calls International callsHow to place telephone calls in foreign countries How to receive callsTeleph. number Blaupunkt You enter +49512149 TipPhone book menu 107How to enter a name/text Phone book menuFinding an entry by name Prevent access Show my phone numberCheck capacity Add entry Finding an entry by positionAltering, deleting, moving or copying the entry Press CL, the altered setting will not be stored Programming with DSC TelephoneStore/confirm End DSCProgramming with DSC Telephone -Setup menu Programming in the setup menuSelect the setup menu by pressing 113Ringing tone volume Automatic answer Operating mode Hands-free volumeHandset volume Automatic redialSMS tone Call meter formatAudible call timer Set charge parametersPIN code EnteredAlter access code Following settings will be deletedExternal alarm Be sure to make a note of the new code if you change itOverview of the basic factory settings in the set-up menu Extended menu Ring signalHands-free channel TA during call Hands-free operation is possible on all four channelsPress CL, the new setting will not be stored Programming with DSC Telephone -Call menuProgramming in the Call Menu 119Call mailbox Received SMS messages Selecting the messageReading messages Press OK You can display the message by press- ingCalling the sender or another telephone Sending SMS messagesSender Network selection Cell Broadcast Call meters Call forwardingCall barring Phone lock Fixed dial numbersOverview of the basic factory settings in the call menu Closed user groupGlossary Specifications AmplifierTuner TelephoneIndex Index Service numbers 042 175 873Bosch Gruppe