Blaupunkt TCM 169 operating instructions Installation, Accessories

Page 7

Important information

Installation

Have the Radiophone installed in your ve- hicle and serviced by a trained service tech- nician only. Faulty installation or servicing can be dangerous and will result in the ex- piry of your guarantee.

If the vehicle is not adequately shielded against radio frequency signals, electronic fuel injection systems, electronic ABS sys- tems, electronic cruise control systems or other electronic equipment may experience malfunctions.

This equipment must not be operated with- out a suitable externally mounted GSM or combination antenna. The equipment includ- ing the GSM or combination antenna must be installed by an authorised Bosch service centre only.

To ensure trouble-free operation, the posi- tive power supply line must be connected via the ignition and the permanent +12 V lead.

Do not ground the speaker outputs!

Notes on connecting a CD changer, an amplifier or the infrared remote control:

If installation conditions are unfavourable, connecting such accessories as a CD changer, an amplifier or infrared remote control may, in rare cases, lead to interfer- ence with the operation of the telephone. This may result in interference noise, dete- rioration of transmission quality or connec- tions being cut off. In this case, please check the wiring or contact one of our authorised service centres.

Accessories

Use Blaupunkt-approved accessories and spare parts only.

You can use the following Blaupunkt prod- ucts with this car radio:

Amplifier:

All Blaupunkt amplifiers.

Changer:

CDC-A06/-A08 or -A072 (direct connection) CDC-A05, -F05, -A071 require an adapter cable.

Remote control:

Using the infrared remote

control RCT 07 7 607 570 510 you can conveniently control all of the most important func- tions of your Radiophone from the steering wheel.

The operating functions are described in the Quick References.

Handset

Using the Blaupunkt handset 7 607 570 512 it is possible to place telephone calls with or without the hands-free function.

The system will switch automatically from hands-free to handset operation when the handset is removed from the cradle.

Warning:

There is a relatively strong magnet built into the handset.

Keep away anything which will react to mag- netic influence, e.g. diskettes, bank cards, etc. Important data may be deleted.

RadioDEUTSCH

ENGLISHTelefon

TelephoneRadio

71

Image 7
Contents Monte Carlo TCM Remote control RCT 07 optional Contents Radio, Cassette, Changer Option Contents Telephone General information Safety standardsSafety information Important informationEmergency calls Using the telephone while drivingUsing the telephone in critical areas Important informationAccessories InstallationInternational telephone informa- tion GuaranteeBasic information KeyCard and SIM cardStarting up the Radiophone Train KeyCard/SIM cards Training or replace KeyCard/ SIM card using DSCKeyCard and SIM card Removing the KeyCard/SIM cardCare of your KeyCard/SIM card DSC learn modeDisplaying the radio pass data Optical warning of anti-theft protectionSwitching the radio on when the ig- nition is switched off On/off VolumeSwitching the unit on/off with the KeyCard Switching the unit on/off via the ig- nitionEject cassette Track switchSRC Source TS / BNDAF / # Cassette loading slotStoring radio stations Recalling stored radio stations -SeCassette operation Changer operation optional = MIXDisplay Radio operation aFlashing card tongue Tape operationStop this function by pressing or the opposite button Corresponding function must be activated Additional rocker switch functionsAdditional settings possible with AUD DSC mode C ME UnitRadio, tape deck, CD changer optional, auxiliary source Audio modeAF Alternative Frequency REG regional programmeSelecting a waveband Station tuningRadio operation with RDS Radio Data System Entering the frequency directlyStoring radio stations Scrolling through the broadcast- ing networks FM onlySwitching from stereo to mono FM only Selecting the seek-tuning sensi- tivityRecalling stored radio stations Traffic programme station reception with RDS-EON Switching traffic announcement priority on/offAutomatic seek tuning start Switching off the beep toneOperating the cassette deck Care instructions Operating the cassette deckTape equalisation Dolby B NRCD changer operation optional Switching CD changer operation onSelecting the CD and the track Store CancelSelect AlterProgramming with DSC Radio, Cassette, Changer optional = ignition timer switched offCards can only be programmed with the help of the DSC menu Music/voice is switched offOn All of the menu items are available End DSC programming/save changes You can choose among the following oper- ating modesOverview of the DSC default settings Telephone operation Reactivating the SIM card Operating the telephonePIN code Inserting the SIM card/ entering your PIN codeDo not hang up until you are told to do so Operating the telephoneMaking your first telephone call GSM emergency callsSelection buttons Quick reference for using the telephoneVolume On/OffTelephone-book menu Enter PIN code Setup menu/Call menuTo switch back to the telephone mode Press briefly Displays Radio menu@ Rocker switch Save telephone numbers and names Using the telephoneGSM network service area Switching to telephone modeDialling a telephone number Using the telephoneSave telephone numbers from the note- pad Redial functionAnswering/ending a call AutomaticBroker’s call/hold Call waiting 2nd callerInternational calls Making telephone calls using the handset special accessorySetting up a conference call Conference callsTip How to place telephone calls in foreign countriesHow to receive calls Teleph. number Blaupunkt You enter +49512149107 Phone book menuPhone book menu How to enter a name/textFinding an entry by name Show my phone number Prevent accessCheck capacity Finding an entry by position Add entryAltering, deleting, moving or copying the entry End DSC Press CL, the altered setting will not be storedProgramming with DSC Telephone Store/confirm113 Programming with DSC Telephone -Setup menuProgramming in the setup menu Select the setup menu by pressingAutomatic redial Ringing tone volume Automatic answer Operating modeHands-free volume Handset volumeCall meter format SMS toneEntered Audible call timerSet charge parameters PIN codeBe sure to make a note of the new code if you change it Alter access codeFollowing settings will be deleted External alarmHands-free operation is possible on all four channels Overview of the basic factory settings in the set-up menuExtended menu Ring signal Hands-free channel TA during call119 Press CL, the new setting will not be storedProgramming with DSC Telephone -Call menu Programming in the Call MenuPress OK You can display the message by press- ing Call mailbox Received SMS messagesSelecting the message Reading messagesSending SMS messages Calling the sender or another telephoneSender Network selection Cell Broadcast Call forwarding Call metersCall barring Fixed dial numbers Phone lockClosed user group Overview of the basic factory settings in the call menuGlossary Telephone SpecificationsAmplifier TunerIndex Index 042 175 873 Service numbersBosch Gruppe