Silvercrest KH 2375 operating instructions Replacing the fuse, Troubleshooting

Page 69

Replacing the fuse

The car radio is equipped with a 10 A fuse on the rear panel, which blows if a voltage peak or a short circuit should occur.

In this case replace the fuse with one of equal value and of the same type as listed in the tech- nical data with the same trip characteristics.

Before switching the car radio on again remedy the cause of the fuse burnout.

No sound

The volume is set to minimum.

• Increase the volume.

The cables are not connected correctly.

• Check the cable connections.

Function buttons are not functioning

There is a malfunction with the device.

• Press the RESET button.

The face plate is not correctly installed.

Check to see that the face plate is installed correctly.

Troubleshooting

The device will not switch on

The ignition is not switched on

Switch the ignition on by turning the key. One of the fuses is defective.

Replace the fuse.

The CD will not load or eject

A CD is already inserted into the car radio.

• Remove the CD.

The CD has been inserted the wrong way up.

Insert the CD with the inscripted side up. The CD is dirty or defective.

Clean the CD or insert a different CD. The temperature in the vehicle is too high.

Wait until the surrounding temperature has normalized.

Condensation on the laser lens

Switch the car radio off for a few hours and then try it again.

The CD jumps

The mounting angle exceeds 30°.

Correct the mounting angle. The CD is very dirty or defective.

Clean the CD or insert a different CD.

Failure with burnt CDs

Check the burnt CD in another playback device.

The radio and/or the automatic station memory is not functioning

The antenna cable is not connected correctly.

Check the antenna cable for correct connection. The station signals are too weak.

Set the station manually.

Station memory is not functioning

The connection 6 in the ISO block A (Permanent positive) is not connected correctly.

• Check the cable connections.

For this consult the chapter "Connections".

The device's USB port does not function

The USB port is intended for devices that function according to the USB standard. Not all market avai- lable devices conform to this standard. It is possible that a device is connected that does not function according to the USB standard.

Connect a device that functions according to the USB standard.

- 67 -

Image 69
Contents Radio CON Bluetooth Para EL Coche Autoradio Bluetooth E r Funciones de radio ManejoReproducir CD de MP3 Reproducir CD de audioUso conforme al previsto Volumen de suministroDatos técnicos Declaración de conformidad CENota acerca de la manipulación de las pilas Indicaciones de seguridad¡Riesgo de explosión Para evitar daños por cortocircuito¡Peligro de radiación láser Elementos de mandoSeguridad de vial Debajo del panel de mandoMontaje ConexiónIndicación Ocupación de las conexiones ISO Problemas de confusión de cablesInstalación de la radio en la ranura ISO AdvertenciaDesmontar el aparato Conexión Backup¡Cuidado Conexión de corriente de la antenaColocar el panel de mando Panel de mandoInsertar las pilas Extraer el panel de mandoManejo Funciones de radio Configurador del regulador múltipleSeleccionar frecuencia de radio Búsqueda automática de emisoraAcceder a la emisora Memorizar la emisoraAlmacenar automáticamente Reproducir la emisora almacenadaTA Traffic Announcement Reproducir CD de audioESP Electric Shock Protection Indicaciones adicionales para el modoReproducir CD de MP3 Buscar según título números Indicación Creación de CDs de MP3 ID3TAGsBuscar según índices Archivos WMALector de tarjetas Conexión USBReproducción Grabación de CDs de audioAdvertencia sobre la grabación de datos Modo BluetoothConexión Acoplar el teléfono con la autorradioUtilizar el micrófono ManejoAudio-Streaming A2DP Eliminación de fallos Sustitución de fusiblesEvacuación Limpieza¡Advertencia Burgstrasse Garantía y asistencia técnica ImportadorUn número de referencia número RMA y Para seguir el proceso de garantíaPage País Teléfono Fecha / Firma Descripción del fallo Radio CON Bluetooth Para EL Coche KHPage Funzioni radio UtilizzoRiproduzione CD MP3 Riproduzione CD audioDati tecnici Uso conformeFornitura Conformità CEAvvertenze relative alluso delle pile Avvertenze di sicurezzaPericolo di esplosione Per evitare danni da cortocircuitoElementi di comando Pericolo radiazione laserSicurezza nel traffico Telecomando InstallazioneUnità microfono Istruzioni di montaggioInstallazione della radio nel vano ISO Problemi dovuti allinversione dei caviConnessione AvvertenzaAttenzione Schema di connessioneAttacco per la corrente dellantenna Attacco di back-upSmontaggio dellapparecchio FrontalinoTelecomando Utilizzo Funzioni radio Reset Reimpostazione radioImpostazioni del multiregolatore Selezione dellampiezza di bandaRichiamo dellemittente Salvataggio delle emittentiSalvataggio automatico Richiamo delle emittenti salvateESP „Electric Shock Protection Riproduzione CD audioAltre indicazioni per il funzionamento con CD Codici PTYAvvertenza Creazione di CD MP3 ID3TAG Riproduzione CD MP3Ricerca di brani numeri Ricerca di directoryFile WMA Lettore di schede Attacco USBRiproduzione Registrazione da CD audioPairing del telefono con lautoradio Modalità BluetoothAvviso relativo ai file di registrazione ConnessioneUtilizzo Impiego del microfonoEliminazione dei guasti Sostituzione del fusibilePulizia La connessione Bluetooth non funzionaSmaltimento Lapparecchio di lettura delle schede non legge la schedaContattare la nostra hotline di assistenza Garanzia e assistenza ImportatoreReclamo telefonicamente, si riceverà Razione della garanziaPage Garanzia Autoradio Bluetooth KHPage Radio functions OperationUSB port Card reader Record function Bluetooth operation Playing audio CDsPlaying MP3-CDs Technical Data Items supplied Intended UseCE Conformity Information regarding the handling of batteries Safety informationRisk of explosion To avoid damage through short circuitsOperating Elements Traffic safetyFront panel face plate Behind the face plateRemote control InstallationInstallation instructions ConnectionInstalling the radio into the ISO duct Configuration of the ISO connectionsPlace the installation bracket into the ISO mounting duct Check to make sure that the bracket is securely fixedConnection schematic Antenna power connectionBackup connection Disassembling the deviceInserting the battery Remote controlFace plate Putting the face plate onReset Reset the radio Setting the operating modeOperation Basic operationRadio functions Settings for the multi controllerSelecting the band range Automatic station searchProgramming stations Accessing the stationAutomatic saving Running through saved stationsASP Anti shock protection Playing audio CDsFurther information for CD operation PTY identificationCreation of MP3-CDs ID3TAGs Playing MP3-CDsTitle search by numbers Search for directoriesWMA files Card reader USB portPlayback Recording from audio CDsInformation regarding the recorded data Bluetooth operationConnection Coupling a telephone with the car radioUsing the microphone OperationAudio streaming A2DP Replacing the fuse TroubleshootingBluetooth connection does not function CleaningDisposal Card reading device does not read the cardsContact our Service Hotline Warranty and Service ImporterPage Bluetooth car radio Warranty