Operation
Operation via the buttons on the device and on the remote control
Most of the functions can be operated by the buttons on the device as well as by the buttons on the remote control. In these instructions the buttons on the device are described.
If the buttons on the remote control are meant this will be specifically mentioned.
Note
Approx. 5 seconds after a setting has been made the playback will again be displayed and the setting is saved.
Basic operation
Switching On and Off
Press briefly the POWER/DIM button to switch the radio on. In the display the notice WELCOME appears.
•Briefly touch the POWER/DIM button to dim the dis- play illumination.
To switch off hold down the POWER/DIM button longer.
Volume
•Turn the multi controller to increase or decrease the volume.
Attention!
Always set the volume to a level that will allow you, at any time, to clearly hear acoustical signals from emergency service vehicles!
Bass/Treble/Balance/Fader
•Press the multi controller to display the current settings for the Bass (BASS), Treble (TREBLE), Balance (BALANCE) and Fader (FADER) .
•Turn the multi controller to change the settings.
Loudness
•Hold down the MD/LD button to switch the loudness function on or off.
Display
•By pressing the DISP button you can switch the notices in the display around in the following manner:
With radio reception:
Programme name, time of day (will automatically be set with RDS reception), PTY settings (these RDS functions are transmitted by the broardcast institu- tions in various extents; see also the chapter "Radio functions") and frequencies.
In CD mode:
Time of day, PTY settings and frequencies.
Note
If you do not receive any RDS or PTY information "PS NONE" or "PTY NONE" appears in the dis- play. Each notice only appears for a few seconds.
Setting the operating mode
•Press the MD/LD button to switch between radio re- ception (frequency indicator), CD/MP3 operation (CD), card slot (SD/MMC), USB port (USB) and audio input (AUX).
Note
The operating modes CD, SD/MMC and USB can only be accessed when the corresponding medium is inserted.
RESET - Reset the radio
•To reset the car radio to its factory default settings press the RESET button with a pointed object, for example a ball point pen.
•Reset the car radio:
-at initial operation,
-after the cable connection,
-if not all function buttons are working
-when an error message appears in the display.
- 58 -