Alpine CDA-7878R Adjusting the Time Correction, Storing the adjustments, Direct Recalling

Adjusting the Time Correction

9 Press the BAND button to select the channel to be adjusted.

2 way system
→Low		→		Low		→ Front high
	range (L)			range (R)			range (L)
	Rear high∗		← Rear high		←		Front high	←
	range (R)			range (L)			range (R)
3 way system
	Low range			Low range		→	Mid range
→		→		(R)			(L)
	(L)
	High range∗			High			Mid range
	(R)		← range (L)		←		(R)	←

∗Press the MODE button to switch to the Cut-off frequency/Slope Adjusting mode.

10 Rotate the Audio Control knob to adjust the

value of the Time Correction (0.0 - 20.0).

11 To adjust another channel, repeat the steps 9 to 10.

12 When all the adjustments are completed, press and hold the DIVIDER button for at least 2 seconds to cancel the Adjusting mode.

Storing the adjustments

You can store the adjustments.

13 Press and hold the MODE button for at least 2 seconds to store the settings (Or press the 1 or 2 button).

The display flashes.

14 While the display is flashing, press the 1 or 2 button.

The divider and the Time correction settings are stored.

15 Press the DIVIDER button to return to normal mode.

NOTES

•About the 2 way/3 way system

You can switch to 2way/3 way system mode with the 2 way/3 way switch on the side of the unit. (See on page 45)

3WAY	When setting to “3 WAY”:
	The unit can be operated in 3-way
	system.
	When setting to “F/R/Sub-W”:
F/R/Sub-W	The unit can be operated in 2-way
	system.

•You cannot use the L.P.S. and Time Correction at the same time.

Recalling the Stored Crossover/ Time Correction Settings

1 Press the DIVIDER button.

2 Press the g DN or f UP button to select the stored content (Memory 1 or Memory 2).

Direct Recalling

Press the [1] or [2] button to recall the stored adjustment.

3 Press the DIVIDER button to return to normal mode.

NOTE

If you press the MODE button in step 2, the unit switches to adjusting mode.

33-EN