Alpine CDA-7878R Blackout Mode On and Off, Switching the Display Modes, Source, SRC DHE on

Basic Operation

TUNE DISP/B.OUT T.S.M.

g DN

f UP

TITLE SETUP

Blackout Mode On and Off

When the Blackout mode is turned on, the display will turn off to reduce power consumption.

This additional power enhances the sound quality.

1 Press and hold the B.OUT button for at least 2 seconds to start the blackout mode. By doing so the display will turn off.

NOTE

If any button on the unit is pressed during the blackout mode, the function will be displayed for 5 seconds to show the operation before returning to Blackout mode.

To cancel the blackout mode, press and hold the B.OUT button for at least 2 seconds.

Switching the Display Modes

You can select the display pattern mode from three display patterns. You can also deactivate the display.

1 Press the DISP (DISPLAY) button to select the desired Display pattern mode.

Each press changes the display patterns.

→Pattern1 → Pattern2 → Pattern3 → Display OFF

2 Press the f UP button repeatedly to select "SRC DHE."

Each press of the f UP button changes the modes as shown:

FM-LEVEL↔REGIONAL↔ PI SEEK ↔TUNER↔SUB-W

↔	↔
DEMO	SUB-W
↔
	(switching phase)∗
CONTRAST
↔	↔
AUX	SUB-W
↔	STEREO/MONO∗
MUTE
	↔
↔

SCROLL ↔ BEEP ↔ DISC/FOLDER ↔ SRC DHE

∗Displayed when you set SUB-W to ON.

NOTE

If you press the g DN button, the display scrolls in reverse sequence.

3 Press the TUNE button to toggle the mode between SRC DHE ON and SRC DHE OFF.

SRC DHE ON:

You can set the DHE/EQ independently for each music source (e.g., radio, CD, MP3, etc.).

SRC DHE OFF:

You can set the same DHE/EQ for all the music sources at the same time.

NOTE

The initial setting at the factory is SRC DHE OFF.

Setting the DHE/EQ for each Music 4 Press the SETUP button to set the selected

Source	mode.
You can set the DHE/EQ independently for each
music source (e.g., radio, CD, MP3, etc.).
1 Press and hold the SETUP button for at least 2
seconds.

10-EN