Alpine CDA-7878R Turning Power On and Off, Display Angle Adjustment, → Balance → Fader → Volume

Turning Power On and Off

1 Press the POWER button to turn on the unit.

NOTE

The unit can be turned on by pressing any other button

except the eject c button.

The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press and hold the POWER button for at least 2 seconds to turn off the unit.

NOTE

The first time power is turned on, the volume will start from level 12 and the unit will be in the tuner mode.

Display Angle Adjustment

Movable display

The movable display may be adjusted to 3 different angles depending upon user preference.

1 Press the ANGLE 89 button to adjust the angle of the movable display.

NOTES

•The display will close a half minute after the ignition key is turned to the OFF position.

•The adjusted angle of the display is stored in memory. There is no need to re-adjust the angle when the power is turned back on.

CAUTION

Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.

Adjusting Volume/Balance

(Between Left and Right)/Fader

(Between Front and Rear)

1 Press the MODE button repeatedly to choose the desired mode.

Each press changes the modes as follows:

→BALANCE → FADER → VOLUME

NOTES

•If the MODE button is not pressed within 5 seconds after selecting the BALANCE or FADER mode, the unit automatically returns to the VOLUME mode.

•When the subwoofer mode is ON, its level may also be adjusted.

•When setting the 3WAY/2WAY switch (page 45) to 3WAY, you cannot adjust the FADER mode.

2 Rotate the Audio Control knob until the desired sound is obtained in each mode.

NOTE

Depending on the connected devices, some functions and display indications do not work.

5-EN