Installation
1
| Rubber Cap |
| (Included) |
Bracket | Hex Bolt |
| (Included) |
Dashboard
Mounting sleeve (Included)
Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard.
No Pressure Here
No Pressure Here
2
Metal Mounting Strap
Screw
∗ Bolt Stud
Hex Nut (M5)
When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the
NOTE
For the screw ∗, provide a proper screw to the chassis installing location.
3 Slide the
Lock pin
Removal
1Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not
2Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
Screws (M5 ⋅ 8) (Included)
Mounting Bracket