Display Angle Adjustment

Movable display

The movable display may be adjusted to 3 different angles depending upon user preference.

1 Press the F button, and when the FUNC indicator blinks, adjust the movable display angle by pressing button F1 (DOWN) or F2 (UP).

NOTES

•The display will close a half minute after the ignition key is turned to the OFF position.

•The adjusted angle of the display is stored in memory. There is no need to re-adjust the angle when the power is turned back on.

CAUTION

Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.

Setting the Front Panel closing mode

1 Press and hold the INTLZ button for at least 2 seconds.

2 Press the f UP button repeatedly to select "CLOSE".

Each press of the f UP button changes the modes as shown:

→FM-LE → REG → PTY31 → AMBER → DIM → SUB → BEEP D-OUT ← CLOSE ← DEMO ← AUX ← SCR ← MUTE ←

NOTE

If you press the DN g button the display scrolls in reverse sequence.

3 Press the TUNE button to toggle mode between CLOSE AUTO and MANU.

•CLOSE AUTO: The Front Panel automatically closes when ACC is on OFF.

•CLOSE MANU: The Front Panel remains open until closed manually.

4 When the setting is completed, press the INTLZ button for at least 2 seconds to return to the normal mode.

Adjusting Volume/Balance

(Between Left and Right)/Fader

(Between Front and Rear)

1 Press the MODE button repeatedly to choose the desired mode.

Each press changes the modes as follows:

→VOLUME → BALANCE → FADER

NOTES

•If the MODE button is not pressed in 5 seconds after selecting the BALANCE or FADER mode, the unit automatically returns to the VOLUME mode.

•When the subwoofer mode is ON, its level may also be adjusted.

2 Rotate the Audio Control knob until the desired sound is obtained in each mode.

NOTE

Depending on the connected devices, some functions and display indications do not work.

Adjusting Source Signal Level

If the difference in volume level between the CD player and FM radio is too great, adjust the FM signal level as follows.

1 Press and hold the INTLZ button for at least 2 seconds.

2 Press the f UP button repeatedly to select "FM-LE. (FM-LEVEL)".

Each press of the f UP button scrolls the modes as follows:

→FM-LE → REG → PTY31 → AMBER → DIM → SUB → BEEP D-OUT ← CLOSE ← DEMO ← AUX ← SCR ← MUTE ←

NOTE

When you press the DN g button, the display scrolls in the reverse sequence.

3 Press the TUNE button to select the FM signal level mode. Each press toggles between "FM- LEVEL HI" (High) and "FM-LEVEL LO" (Low).

4 Press and hold the INTLZ button for at least 2 seconds to activate the normal mode.

5-EN