Texas Instruments 3000 MCU manual Network Clocked T1 Facilities

SpectraLink Corporation	T1 Remote Module Installation
	Link WTS – Link 3000 MCU

Network Clocked T1 Facilities

If the T1 facilities are Network Clocked, one T1 Remote Module must be designated as the Master Clock Source. Connect the Sync IN port on this T1 Remote Module to AUX port A on the Intershelf Junction Panel. Note, this shelf must also be designated as the Master Clock in the system configuration.

Connect T1 Facilities

Connect the RJ48C jack from the CSU port at the local end to the DS1 A and DS1 B ports on the T1 Remote Module. Port A controls slots 3-7 on the remote module at the far end. Port B controls slots 8-12.

The following diagram shows the T1 Remote Module connections at the LOCAL site.

Part Number: 72-0059-06-E.doc Page 15