VeriFone 8000 manual Connecting the Battery, To insert the battery, To remove the battery

Power off the terminal. See Powering On and Off the Terminal With a Battery Pack.

Remove the battery/card compartment cover. See Figure 4.

SETUP

Connecting the Battery

Connecting the Battery

The NURIT 8000 terminal comes with a Lithium-polymer battery. Read this section to know how to install and remove the battery.

NOTE

Only use batteries provided by VeriFone. For information about purchasing additional or replacement batteries, see Accessories and Documentation.

Depending on your model of the NURIT 8000 terminal, the battery compartment may be shared with the SIM, SAM, and SD cards. To gain access to the battery/ card compartment, you must first remove the battery/card compartment door. For information on removing and replacing the battery/card compartment cover, see Opening and Closing Battery/Card Compartment Cover.

Connecting and The NURIT 8000 allows you to operate the terminal without an external power Removing the supply, by using a battery.

Battery

To insert the battery 1

2Hold the battery, verifying that the side with the metal contacts are facing downwards and that the rounded edge is facing towards the back of the compartment.

3While holding the battery at a 30° angle, slide the two tabs on the front of the battery into the slots on the front wall of the compartment.

4Push the back of the battery down, until it snaps into place.

Figure 9 Inserting the Battery

5Replace the battery/card compartment cover. See Figure 5.

To remove the battery 1

2Remove the battery/card compartment cover. See Figure 4.

3Insert your fingernail into the groove at the back of the battery and lift the battery, snapping the battery out of place.

18 NURIT 8000 INSTALLATION GUIDE