SETUP
Using the Printer
Using the Printer | An integrated thermal printer is built into the NURIT 8000. Before you can process | |
| transactions in the NURIT 8000 that require a receipt or record, you must install | |
| paper in the printer. | |
Loading Paper into | Before using the printer, load a roll of paper into the printer. | |
the Printer |
|
|
To load paper into the | 1 | Place the terminal on a flat, stable surface. |
printer | 2 | Insert two fingers into the recess on the paper compartment cover, beneath |
|
| the release latch. |
| 3 | Pull the opening latch up until the cover unlocks. |
Figure 11 Opening the Paper Compartment
4Remove the tape strip from a new paper roll.
5Unroll approximately 5 cm (2 in) of paper to facilitate the loading process.
6Hold the paper roll with the unrolled end on the underside.
7Lower the paper roll into the paper compartment.
Figure 12 Inserting a Paper Roll
8Pull the unrolled end of the paper approximately 2.5 cm (1 in) out of the paper compartment, ensuring that the paper feeds from the underside of the roll.
9Make sure that the opening latch is down, in its original position.
NURIT 8000 INSTALLATION GUIDE | 21 |