VeriFone 8000 manual Power Supply Connection

Page 23

SETUP

Power Supply

Power Supply The NURIT 8000 gives you the option of running the unit on battery power, or through a power adapter. The power adapter both gives power, as well as

recharges the battery.

For information on using the battery, see Connecting the Battery.

Before connecting a power supply, disconnect the power cord from the power outlet.

Connect and route all cables between the NURIT 8000, ECR, and PC before plugging the power pack cord into a wall outlet or surge protector.

WARNING Use only the VeriFone supplied AC/DC power adapter to power the NURIT 8000. The power adapter provides electrical power to the NURIT 8000 as follows:

•AC/DC adapter (safety approved) Output: 9-10 V at 1 A

WARNING Do not plug the power pack into an outdoor outlet or operate the NURIT 8000 outdoors. Also, disconnecting power during a transaction can cause transaction data files not yet stored in memory to be lost.

NOTE

To protect against possible damage caused by lightning strikes and electrical surges, VeriFone recommends installing a power surge protector.

Connect one end of the power adapter cable to the Power port on the bottom of the terminal and the other into an electrical power outlet.

Figure 15 Power Supply Connection

NURIT 8000 INSTALLATION GUIDE

23

Image 23

Contents Nurit Nurit 8000 Installation Guide VeriFone, Inc Contents Service and Support MaintenanceCleaning TroubleshootingDocument Conventions Audience Organization Related DocumentationGuide Conventions Acronym Definitions Acronym DefinitionsOverview Features at a GlanceNurit 8000 Features GSM Location SetupSelecting Outdoor Use Electrical ConsiderationsIndoor Use Shipping carton Unpacking Shipping CartonTo unpack Nurit 8000 Terminal Features Front Panel Examining Nurit FeaturesThermal printer Terminal Front PanelTo remove the battery /card compartment cover Opening Closing Battery Card Compartment CoverCards Installing SIMTo install a SIM or a SAM card SAM, and SDInstalling and Removing a SIM/SAM Card Inserting the SD/MMC Card To remove the battery Connecting the BatteryBattery To insert the batteryRemoving the Battery Battery MaintenanceBattery Charge LED Indicator Status Powering On Off the Terminal With a Battery PackBattery Charge Status To load paper into Using the PrinterLoading Paper into PrinterTo remove a roll Roll FromClosing the Paper Compartment Removing the PaperPower Supply Connection Adapter Car Adapter ConnectionTo connect the car adapter To connect the data cable Connecting CablesTo disconnect CableExternal Modem Connection To connectStripe card reader Using Magnetic Stripe Card ReaderTo use the magnetic Reader Using the Smart Card ReaderRegulatory, SpecificationsSpecifications EnvironmentalReference Ieee 1725, Section 8000 Maintenance and CleaningCleaning the Nurit Cleaning the Nurit Troubleshooting Guidelines Transactions Cannot be Completed Successfully Nurit 8000 Appears to Have No PowerWireless Communication Does Not Work Successful Operation withPeripheral Device NotKeypad Does Not Respond Service and Support Information Label on Unit Bottom Accessories DocumentationKit Documentation VeriFone CleaningCables Adapters External ModemAccessories and Documentation Index Service Index Nurit