To Light, To Turn Off, To Store, English-5

	To Light	D Brightness may be
	To Light	adjusted with
	WARNING	fuel valve. (Fig. 23)
	WARNING
	If you smell gas:
	1. Do not attempt to light appliance.
	2. Extinguish any open flame.	Fig. 23
	3. Disconnect from fuel supply.	Fig. 23
	3. Disconnect from fuel supply.
	4. Call 1-800-835-3278.
	WARNING	D The lantern may be
	WARNING	carried by the
	• Replace any mantle with a hole in it. A hole	handle. (Fig. 24)
	• Replace any mantle with a hole in it. A hole
	can cause lantern to overheat and create a
	hazard. Never operate lantern without
	heat shield.
	CAUTION
	• SERVICE SAFETY
	• Keep all connections and fittings clean.
	Inspect propane cylinder and lantern propane	Fig. 24
	connections for damage before attaching.

•During set up, check all connections and fittings for leaks using soapy water. Bubbles

	indicate a leak. Never use a flame.	To Turn Off
	indicate a leak. Never use a flame.
	Battery	D Turn fuel valve
	INSTASTART™	D Turn fuel valve
	INSTASTART™	off. (Fig. 25)
	Electronic
	Ignition Lantern
	D Push ignitor button
	and hold; then turn
	fuel valve on. (Fig. 21)	Fig. 25
		Fig. 25
		To Store
		Fig. 21

	WARNING	D Make sure lantern is cool.
	WARNING	D Move lantern away from flame (including pilot
		D Move lantern away from flame (including pilot
		lights) and other ignition sources.
		D Fold feet on lower carry case. (Fig. 26)

• BURN HAZARD
• Never leave lantern unattended when hot or
in use.
• Keep out of reach of children.
NOTE: If lantern does not light, repeat above step
after turning fuel valve completely off. If the
lantern is wet due to rain, high humidity, etc., the
ignitor may not spark. Use match lighting	Fig. 26
procedure as follows.
Match Light	D Unlock the lower carry case and remove from
Lantern	the upper carry case. (Fig. 27)
D Push lighted match
through lighting hole,
hold near mantle and
open fuel valve fully.
(Fig. 22)
Fig. 22	Fig. 27
English-5

To Light