Error Codes
Care and Maintenance
Or to indicate an error in speed or incline:
INVALID INCLINE DATA | (bAd grad dAtA) |
INVALID SPEED DATA | (bAd SPd dAtA) |
CALIBRATION ABORTED: | (CAL StOP) |
NO SPEED SENSOR | (nO SPd SEnS) |
Care and Maintenance
4. Remove and replace Safety Key and exit Calibration Mode
The following Error Codes and Service Codes will follow a double “beep” and show on the display. Service Codes provide preventative maintenance reminders. A Service Code will repeat for the next five times you start the treadmill. A Service Code will clear after any key has been pressed. When an Error Code occurs, call an authorized service technician.
Z8.1/9/9.1/9.15 | Z8 | Description | |
E1: MINIMUM | E1 | Not used | |
|
| This error occurs when the incline values on the | |
E1:RANGE | E1 r | display do not match the values stored during | |
|
| calibration. | |
E1:STALL | E1 S | This error occurs when the incline motor does | |
not move in response to an incline command. | |||
|
| ||
E1:INCLINE | E1 i | This error occurs when the incline motor moved | |
without an incline command. | |||
|
| ||
E2:OVERSPEED | E2 O | This error occurs when acceleration exceeded | |
design limits. | |||
|
| ||
E2:CAL | E2 C | This error occurs when the speed displayed does | |
|
| not match the stored value from calibration. | |
|
| This error occurs when a data error is detected | |
E2:RECAL | E2 r | at start up. The Control Panel has reset to de- | |
|
| fault values. | |
E5:SENSOR | E5 S | This error occurs when no speed sensor data has | |
|
| been detected at the Control Panel. |
Error and
Service Codes
66
Z 8 a n d Z 9 S e r i e s Tr e a d m i l l O w n e r ' s G u i d e