JVC RX-5060B manual Operating Other Manufacturers’ Video Equipment

Operating Other Manufacturers’ Video Equipment

To change the transmittable signals for operating another manufacturer’s VCR

1Press and hold STANDBY/ON VCR.

2Press VCR.

3Enter a manufacturer’s code using buttons 1 – 9, and 0.

Manufacturer	Codes
JVC	01*, 02, 03
Emerson	10, 22
Gold Star	11
Hitachi	04
Mitsubishi	12
NEC	21
Panasonic	07, 13
Philips	09
RCA	05, 06
Samsung	20
Sanyo	17, 18, 19
Sony	14, 15, 16
Zenith	08

* “01” is the initial setting.

4 Release STANDBY/ON VCR.

Now you can perform the following operations on the VCR:

STANDBY/ON	VCR: Turn on and off the VCR.
VCR CH +/–:	Change the TV channels on the
	VCR.

After pressing VCR, you can perform the following operations on the VCR:

To change the transmittable signals for operating another manufacturer’s DVD player

1Press and hold STANDBY/ON DVD.

2Press DVD.

3Enter a manufacturer’s code using buttons 1 – 9, and 0.

Manufacturer	Codes
JVC	01*
Panasonic	02
Philips	04
Pioneer	03
Sony	05
Toshiba	06
Yamaha	07

* “01” is the initial setting.

4 Release STANDBY/ON DVD.

Now you can perform the following operations on the DVD player:

STANDBY/ON DVD: Turn on and off the DVD player.

After pressing DVD, you can perform the following operations on the DVD player:

3: Start playing.

4: Return to the beginning of the current (or previous) chapter (or fast reverse for some models).

¢: Skip to the beginning of the next chapter (or fast forward for some models).

7: Stop playing.

8: Pause playing. To resume, press 3.

3:	Start playing.
REW:	Rewind the tape.

FF:Fast-forward the tape.

7:Stop playing or recording.

8:Pause playing. To resume, press 3.

REC PAUSE: Enter recording pause.

To start recording, press this button then 3.

5 Try to operate your VCR by pressing

STANDBY/ON VCR.

After pressing DVD, these buttons can be used for the DVD menu operations.

Note:

For detailed menu operations, refer to the instructions supplied with the discs

or the DVD player.

2

46

MENU

7/P 8

ENTER

10

When your VCR turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of

VCR, try each one until the correct one is entered.

5 Try to operate your DVD player by pressing

STANDBY/ON DVD.

When your DVD player turns on or off, you have entered the correct code.

Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

32