Getting Started
Do not connect the AC power cord until all other connections have been made.
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.
Before Installation
Note:
Supplied batteries are for the initial setup. Replace for continued use.
General Precautions
•Be sure your hands are dry.
•Turn the power off to all components.
•Read the manuals supplied with the components you are going to connect.
Locations
•Install the receiver in a location that is level and protected from moisture and dust.
•The temperature around the receiver must be between
•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.
Handling the receiver
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity: (+) to (+) and
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
Connecting the FM and AM (MW)
Antennas
FM antenna connections
•Do not insert any metal object into the receiver.
•Do not disassemble the receiver or remove screws, covers, or cabinet.
•Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are supplied with the receiver.
The number in the parentheses indicates quantity of the pieces supplied.
•Remote Control (1)
•Batteries (2)
•AM (MW) Loop Antenna (1)
•FM Antenna (1)
If anything is missing, contact your dealer immediately.
AB
| AM |
| AM |
EXT | LOOP | EXT | LOOP |
AM |
| AM |
|
ANTENNA | ANTENNA |
Extend the supplied FM antenna horizontally.
Putting Batteries in the Remote Control
Before using the remote control, insert the two supplied batteries first.
1 | 2 | 3 | ||||
| AA(15F) |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1Press and slide the battery cover on the back of the remote control.
2Insert the batteries.
• Make sure to match the polarity: (+) to (+) and
3Replace the cover.
If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two
AM EXT
AM | FM Antenna | |
(supplied) | ||
LOOP |
ANTENNA | Outdoor FM Antenna Cable |
| |
| (not supplied) |
Connect the supplied FM antenna as temporary measure to the FM 75 Ω COAXIAL
If reception is poor, connect the outdoor FM antenna (not
1Disconnect the supplied FM antenna.
2Connect a 75 Ω coaxial cable with the standard type connector (IEC or DIN45325).
4