Auto SURROUND* Plii Game

Activating the Surround Modes

Available Surround modes vary depending on the incoming signals.

Activating one of the Surround modes for a source automatically recalls the memorized settings and adjustments (see pages 16 to 22).

Auto Surround Function

This receiver has Auto Surround Function, which allows you to enjoy the Surround mode simply by selecting the source (with digital input selected for that source).

Auto Surround works...

•When multi-channel signal is detected, an appropriate Surround mode will be turned on.

•When Dolby Digital 2-channel with surround signals is detected, “PLII MOVIE” will be selected.

•When Dolby Digital 2-channel without surround signals or Linear PCM signal is detected, “SURROUND OFF” will be selected.

Note:

This function does not take effect in the following cases:

–While playing an analog source,

–While selecting any of DSP modes (see page 26), and

–While listening with the headphones—“HEADPHONE” or “3D H PHONE” (see pages 11 and 24).

Activating the Surround Modes Manually

1Select and play any source.

•Make sure you have selected the analog or digital input mode correctly.

2Press SURROUND to activate the Surround mode.

•When “DOLBY DIGITAL,” “DTS SURROUND,” or “DUAL MONO” is selected as the Surround mode, pressing SURROUND changes the indication on the display alternately between “AUTO SURROUND” and each Surround mode. (The surround effect does not change.)

•For Dolby Digital multi-channel digital software (except

2-channel and Dual Mono software), incoming signals are automatically detected and “DOLBY DIGITAL” is activated.

•For DTS multi-channel digital software (except 2-channel and Dual Mono software), incoming signals are automatically detected and “DTS SURROUND” is activated.

Note:

When the Dolby Digital or DTS multi-channel digital signal stops coming in, “PLII MOVIE” will be activated.

•For analog sources and digital 2-channel software, you can select one of the following Surround modes. Each time you press SURROUND, Surround modes change as follows:

PRO LOGIC

PLII MOVIE		PLII MUSIC

(Dolby Pro Logic II Movie)		(Dolby Pro Logic II Music)

(Dolby Pro Logic II Game)

*The receiver automatically changes the Surround mode to “PLII MOVIE” or “SURROUND OFF” according to the input signal.

•For Dual Mono software, you can select the channel you listen to. (See page 19.)

DUAL MONO

To adjust the speaker output level, center tone, and sound effect of Dolby Pro Logic II Music, see page 22.

To cancel the Surround mode

Press SURROUND/DSP OFF.

When playing Dolby Digital Surround EX or DTS-ES software

You can enjoy Virtual 6.1-channel playback using Virtual Surround Back.

To activate Virtual Surround Back, see page 20.

VIRTUAL SB

JVC RX-5060B manual Auto SURROUND* Plii Game