Image IMTL11997 Trouble-Shooting, Problem The power turns off during use, Solution, Power cord

Page 23

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-

free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position.

PROBLEM: The power turns off during use

c

 

Tripped

Reset

d

On

 

 

Position

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Unplug the power cord, wait for five minutes, and then plug the power cord back in.

d. Remove the key from the console. Reinsert the key fully into the console.

e. Make sure that the on/off switch is in the on position.

f. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly

 

SOLUTION:

a. Remove the key from the console and

 

unplug the

 

power cord.

Carefully tip the treadmill down as shown

 

in drawing a. Remove the Screws (39, 83) from the

 

 

hood. Raise the Uprights (69) and carefully remove

 

 

the hood.

 

 

 

 

Locate the Reed Switch (10) and the Magnet (7) on

 

 

the left side of the Pulley (8). Turn the Pulley until the

 

Magnet is aligned with the Reed Switch.

Make sure

 

that the gap between the Magnet and the Reed

 

 

Switch is about 1/8”.

If necessary, loosen the Screw

 

(80) and move the Reed Switch slightly. Retighten the

 

 

Screw. Re-attach the hood, and run the treadmill for a

 

 

few minutes to check for a correct speed reading.

 

a

 

 

39

69

83

1/8”

8

80

 

10

7

Top

 

View

 

23

Image 23
Contents Customer HOT Line To Avoid DELAYS, Please Call Direct to OUR TollQUESTIONS? Table of Contents Same circuit. Do not use an extension cord Important PrecautionsUse the treadmill only as described in this manual Wear appropriate exercise clothes whenNever insert or drop any object into any opening Inspect and tighten all parts of the treadmill regularlyRight Side Using the treadmillBefore YOU Begin Left SideMake sure that Extension Legs 102 remain in the Uprights AssemblyAssembly requires two people Do not tighten the Bolts yet Surge suppressor must be electrically rated HOW to Plug in the Power CordPerformant Lube Use only a single-outlet surge suppressor that isVideo Features of the ConsoleGetting Started HOW to USE the Manual Mode Stand HOW to USE Preset ProgramsWalking belt and remove the key Measure your heart rate, if desiredManually AllGram display To the left HOW to Create Custom ProgramsSelect one of the custom programs Press the Start button or the Speed + buttonFollow your progress with the displays HOW to USE Custom ProgramsCline setting during the current segment When the program has ended, remove the keyVideocassettes HOW to Connect Your Portable CD PlayerHOW to Connect Your Portable Stereo Headphones/Speakers HOW to Connect Your Home StereoCable Wire removed from Line OUT jack HOW to Connect Your ComputerPrograms HOW to Connect Your VCRSee the instructions near the bottom Next settings of the CD or video programStart button or the Speed ConsoleHOW to USE Programs Directly from OUR WEB Site Buttons on the console will not operate If a d ap Pears Information MODE/DEMO ModeInformation mode is selected, press Speed Important The Heart Rate/Calories displayHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Move the TreadmillPower cord TROUBLE-SHOOTINGProblem The power turns off during use SolutionCentered Problem The walking belt slows when walked onPower Cord Shifted to the leftExercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesQty Description Key No. Qty Part LIST-Model No. IMTL11997Ordering Replacement Parts Part No R0202A Limited WarrantyWhat is COVERED-The entire Image By warrantyDRAWING-Model R0202A